Thanks for the video. Was helpful. Also a tip for doing a hot oil change is to use foil to keep the oil from getting on the hot header
@hoorah251
2 жыл бұрын
Problems with this oil change. 1. Always change your oil when it's hot 2. Putting a plastic bag on a hot header will melt, just loosen the oil filter let the majority of the oil drain out, remove the filter. 3. Always prime your new oil filter by adding some oil into it before installing. 4. Oil filters only need to be hand tight DO NOT tighten with a wrench. 5. Do NOT use regular automotive oil in your bike Always use motorcycle oil, using automotive oil can cause shifting problems and premature wear to your clutch. 6. After draining the old oil installing a primed oil filter with clean oil on the rubber gasket. Pour in 10W40 motorcycle oil. 7. yamaha recommends that you start the bike let it run for a few seconds Crack the oil filter loose for a second and re tighten, this is to ensure proper oil flow into the filter. 8. After doing the above steps simply clean the oil off your header with brake clean, it removes the oil and evaporates quickly. 9. Double check oil level and Reinstall plastics.
@joshdean5867
6 ай бұрын
1. Yes. 2. no , exhaust cools down within minutes 3. Don't need to prime filter as it's horizontal. 4. Yes 5. Yes 6. Already covered 7 . Yes 8 . Yes 9. Yes
@kennyschneider4482
3 жыл бұрын
Camera is way to close , you sure that's an 02 r1 ?
Пікірлер: 6