I worked on a 2009 Toyota Sienna and the part number on the bushing seem to be the same. I used the dorman 14797. Got it at auto zone. Looks a little different but it works. I put the bushing on the shifter pin first then slid the cable loop second. Works well.
@jakobfred
2 жыл бұрын
I came up with a solution for the bushing that cost me nothing. I made one out of a piece of 1/4 ID x 3/8 OD plastic hose I had sitting in my basement. The inside diameter is tight going on the metal post. Which makes for a nice fit. The outside is a little small also which allows the cable to fit on nicely. I cut it .285 wide. I then cut another piece .150 wide to go over the metal pin to act as a retainer.
@uniteamerica9446
Жыл бұрын
Thank you for the video. You made it look easy. Just a helpful tip, at 0:32 the correct word is pry not prime. Your English is better than my Spanish though as I don't speak Spanish.
@brianhobbs8950
5 жыл бұрын
Happened this morning, car won't start because it won't shift. It rolls and I had to put the emergency brake on.
@marcsongaudin8429
4 жыл бұрын
Thanks I bought one on Amazon yesterday I would get by tomorrow because I paid fast shipping so I will try it on Friday.
@nelsonjosuemoraleslobo7354
2 жыл бұрын
What’s the name of the part?
@landaq007
8 ай бұрын
Great help thank you
@izzymtz2822
3 жыл бұрын
Haay mi madre, yo no puedo creer que yo arregle el problema con ayuda de Dios y tuya, gracias, gracias, gracias.. excelente video
@jakobfred
2 жыл бұрын
I came up with a solution for the bushing that cost me nothing. I made one out of a piece of 1/4 ID x 3/8 OD plastic hose I had sitting in my basement. The inside diameter is tight going on the metal post. Which makes for a nice fit. The outside is a little small also which allows the cable to fit on nicely. I cut it .285 wide. I then cut another piece .150 wide to go over the metal pin to act as a retainer.
Пікірлер: 12