This video is how to make a tailstock hex shaped die holder on the MINI LATHE. (MUCH) More information below!
Please like and subscribe if this was helpful!
Stuff from this video:
Green Loctite: amzn.to/2qhVSAd
Tap and Die Set: amzn.to/2pBk6SB
Layout Fluid: amzn.to/2qhZeDr
Knurling Tool: amzn.to/2pI4fCq
Part 2: • (2/3) Making a Tailsto...
Part 3: • (3/3) Making a Tailsto...
Lathe: amzn.to/2nVBrEc
Stuff on the lathe:
Quick Change Tool Holder: amzn.to/2oZtFee
Tailstock Drill Chuck: amzn.to/2pmE0jX
Lathe tools:
Boring Bar: amzn.to/2pmy0b1
Carbide Tools: amzn.to/2oRZWax
Parting Tool: amzn.to/2nVCeW1
Center Bits: amzn.to/2oRRV5n
Drill Bits: amzn.to/2oz9W76
Other stuff:
Cutting oil: amzn.to/2ofkPaY
Mini Lathe troubleshooting guide: littlemachinesh...
Controller board wiring configuration: imgur.com/KIEzu92
The real version of the motor controller: amzn.to/2orw43F
Datasheet for the KBIC-120: www.galco.com/...
Super nice guy who repairs the controller boards: olduhfguy.com/
Негізгі бет Ғылым және технология (1/3) Making a Tailstock Hex Die Holder for Tapping/Cutting Threads on the Mini Lathe
Пікірлер: 157