129Hp & 147ft/lbs with factory heads, it is very hard to go past this 'Stump Puller' Kit from Alpha Performance Engines! Possibly the best bang for buck kit on the market for the M8 engine platform.
This kit uses heavy duty iron lined cylinders, 4.250" X-Forged CP Pistons, 55mm Screamin' Eagle Intake Manifold, 6.2gps fuel injectors with the Cycle-Rama/APE exclusive CR483 Camshaft all while keeping the cylinder heads completely stock!
Other parts included are upgraded 1275nm Clutch springs from Screamin' Eagle & an upgraded compensator ramp from Cycle-Rama.
I take you through the build process from start to finish & explain along the way some of the procedures involved with engine building & assembly.
Please keep in mind that this is KZitem video & as a result has been edited to keep the content enjoyable & flowing. Just because you didn't see the motorcycle being warmed up & heat cycled before the Dyno tuning was carried out doesn't mean it didn't happen. I just don't want to bore you with boring footage of an engine being warmed up & sitting at idle.
The dealership I work for is located 2200ft above sea level & as a result will always show slightly lower than expected Dyno numbers. Proven in other videos on my channel is a comparison of just this with massive gains found on the same bike with the same tune just taken down to sea level.
For more info on the kit or A.P.E check out the website
www.alphaperformanceengines.c...
cycle-rama.com/
Follow me on Instagram / tommy_twincam_miller
I work here ddhd.com.au/
You can call me on 0746342766 during AEST business hours.
Негізгі бет Автокөліктер мен көлік құралдары 124ci RoadGlide / Performance Bagger Build / APE
Пікірлер: 62