Ordering one of these today. Thanks for the awareness.
@stevenbean9706
Ай бұрын
i bought some solder sticks use the red one from the pack and solder sticked a 12ga wire to the two broken wires on my post so its now a wire not a small stud to connect ignition wire to
@mustangdemon87
2 жыл бұрын
Thank you! Spent 500 on a new starter bitch didn't even last 50k miles! Daily driver 12v. Ordered the Larry b heavy duty contact kit! Thanks again
@BRWfilms
Жыл бұрын
About to put mine in from Larry b
@mustangdemon87
Жыл бұрын
@@BRWfilms cool I put mine in about 2-3 months ago now have another 10k miles or so issues free!
@BRWfilms
Жыл бұрын
@@mustangdemon87 well. I guess my starter is actually bad cause it didn't fix it. I can make the starter spin over outside the truck but in the truck with a power probe by passing everything it just clicks won't spin over. I took the starter motor side apart but it looked good can't visually see anything wrong with it
@mustangdemon87
Жыл бұрын
@@BRWfilms can you turn the motor over by hand with a long bar? Maybe you had a injector leak down or weak battery's. It takes almost 800 amps to get these motors to spin.
@BRWfilms
Жыл бұрын
@@mustangdemon87 well I put new batteries and ive tried with a jump starter. I'm about to put a reman denso on it and see what it does
@sirlayo
2 ай бұрын
I appreciate it 🫡
@BRWfilms
Жыл бұрын
You can actually rebuild the starter it's self as well if needed
@stevenbean9706
Ай бұрын
the small post is whats wrong , people over tighten them then you go to take the nut off and it snaps inside nobody ever goes over that small post ! in the past 30-35 years ive had at least 20 or more that are over tight you go to loosen them they snap and spin freely and do zero after ! no power no click no nothing once it snaps its junk and no rebuild kit made fixes em it has to be completely replaced
@jefftucker3387
2 жыл бұрын
You didn't rebuild the starter you rebuilt the solenoid
Пікірлер: 13