Replacing the power board of a DTF printer is a complex process involving electronic components and is usually recommended to be done by a professional technician. However, if you have the proper knowledge and experience in electronic repair, here is a general guideline step:
Power off: Before starting, make sure the printer is turned off and disconnected from the power to avoid electrical risks.
Open the printer housing: Locate and open the housing or cover of the printer in order to access the internal components.
Locate the power board: Locate the power board inside the printer.
Remove the power strip: Use the appropriate tool to remove the screws or clamps holding the power strip in place, and carefully remove the power strip from the printer.
Disconnect: Disconnect all cables and connectors connected to the power board.
Install the new power supply board: Place the new power supply board in place and reconnect all cables and connectors.
Secure the new power strip: Use screws or clamps to secure the new power strip to the printer.
Close the printer housing: After installation, close the printer housing or cover.
Reconnect the power supply and test: Reconnect the printer to the power supply and turn the printer on for testing to make sure the new power strip is working properly.
Precautions: Keep your hands dry during operation to avoid the risk of electric shock. If you are not familiar with electrical maintenance, it is recommended to operate under the guidance of professional personnel.
Негізгі бет 13 How do I replace the power board of a DTF printer?
Пікірлер: 2