Are those needles cast iron? Try heating them up before welding
@deetee6621
3 жыл бұрын
Bent a couple of these earlier today. Was wondering, what angle/shape did you shape the refurbished needle to? Were you aiming for a specific target area, such as in the 4/5 inches of air space behind the notters or maybe you aimed to bring the needles up right underneath the notters. I already know the needles should run in between the two bars but it is the target that is frustrating me as both needles bent so no template. :( In Euro these are €265 each. GBP £200 ….each.
@rollagranchers2604
3 жыл бұрын
Luckily only one needle broke so we were able to use the other as a template.
Пікірлер: 4