Replacing the head plate of a DTF printer (which may refer to the print head or control board) usually requires following these steps:
Power off the printer: Before starting the replacement, make sure the printer is turned off and disconnected from the power to avoid electrical risks.
Open the printer housing: Locate and open the housing or cover of the printer in order to access the internal components.
Locate the head plate: Locate the head plate that needs to be replaced inside the printer.
Remove the old head plate: Use the appropriate tool to remove the screws or clamps holding the head plate in place and carefully remove the old head plate from the printer. Disconnect all wires and hoses connected to the head plate.
Install the new head plate: Place the new head plate in the proper position and secure it as before. Reconnect all wires and hoses.
Test the new head plate: Reconnect the power supply and perform the necessary tests according to the machine's operating manual to ensure that the new head plate is working properly.
Precautions: Keep your hands dry during operation to avoid the risk of electric shock. If you are not familiar with electrical maintenance, it is recommended to operate under the guidance of professional personnel.
Printer parts maintenance includes regular inspection of the condition of peristaltic pumps and filters, and timely replacement. Color ink filters should be replaced within a two-month life cycle, and white ink filters should be replaced within half a month to a month. Replacing the filter on time is conducive to ensuring the life of the nozzle and the printing effect.
Please note that the above steps are general
Негізгі бет 15 How do I replace the head plate of a dtf printer?
Пікірлер: 2