I can't wait to see the next episode of Uncle Mark showing off some antique heavy equipment!
@mistervacation23
16 күн бұрын
We have a NO yelling policy in these meetings
@MarkIrish-bo9mz
25 күн бұрын
totally agree!!!
@MarkIrish-bo9mz
25 күн бұрын
that is why I only do finish work with alice, no hard cutting or digging
@outdoorlifemaine6691
23 күн бұрын
I seen plenty of John Deere model D's that are older than that running in New York
@MarkIrish-bo9mz
23 күн бұрын
yes, lots of jd. d's. left. They had a great run. The obvious difference being a tractor opposed to a road grader.
@ralphnorris-vk8ff
24 күн бұрын
Allis did make bigger graders and they were just as good as the D model. Allis just couldn't compete with adams and cat.
@sallybrokaw6124
26 күн бұрын
Every one of these I've seen here in Ohio the brackets for the vertical lift cylinders for the moldboard table are an ugly welded mess. Underneath the welds are very bad. Most have cracks running everywhere. I suspect shocks and vibrations transfer from the blade up through the cylinders to the brackets. Eventually, fatigue cracks start. If the repairman doesn't remove the crack to the bottom welding over top of it doesn't help. AL B retired weldor fabricator 😊.
Пікірлер: 10