God damn, these comments. You did great mate (probably a lot better than when I have to tackle this soon haha). I don't know what is up with the Mustang community being condescending and rude with people all the time.
@austindowney7142
5 күн бұрын
Hope I was able to help a little bit, but I knew what comments I would get when I posted my DIYer skills online for everyone to see. I'm a first timer on all of this and still have a ton to learn. My goal with my channel is to hopefully encourage others as I don't edit anything out, keep my videos pretty raw, and make plenty of mistakes. If you think the comments here are bad check out the ones on my DIY paint job setup and paint job itself.
@gregorypeterson9
4 ай бұрын
Great Job!! and you did it with a flux core welder.💯💯😎💥💥
@austindowney7142
4 ай бұрын
Thank you, taught myself how to weld (still not great at it) but we are making progress
@matthewbennett9628
28 күн бұрын
Your floor support coming off the frame rail is bent upward, I replaced both driver and passenger floor support on mine
@austindowney7142
27 күн бұрын
Thanks for the input I’m well passed that point now, but I ended up hammering them pretty flat and even off camera and had to re weld them a little bit. Feel free to leave any other suggestions on my videos as I’m learning, thanks!
@larrywarren1049
5 ай бұрын
The under coating on other cars ive been involved with was able to get removed with propane torch and metal tool used for patching drywall name escaping me anyways use drywall tool to scrape heated coating
@austindowney7142
5 ай бұрын
Good to know thanks!
@b67fstb
7 ай бұрын
IIRC , floorpans for coupe/fastback , the lip on outside floorpan faces upwards. By convertibles , this lip faces downwards.
@austindowney7142
7 ай бұрын
Good to know that for the future thanks!
@theresinsamurai4520
Жыл бұрын
you NEED to go over the trans tunnel as well as continue through to the trunk. it is both sound deadening as well as HEAT deadening it makes all the difference in the world you can also take some 2x4 strips of the material and put it INSIDE the door sticking it to the door skin and then a couple on the door itself behind the panel which will keep sound from bouncing around inside the door and that also really helps knock the sound and vibrations down the rest is looking good
@austindowney7142
Жыл бұрын
Sounds good looks like I’ll be throwing some more on, thanks for the suggestion!
@waynevictory5208
Жыл бұрын
It’s a cheap mustang.
@austindowney7142
Жыл бұрын
Yes I bought a cheaper one to learn some skills and build it, but much more expensive then I would have thought to rebuild it.
Пікірлер: 14