Thank you for an excellent instructional video. I'm disassembling the steering coupling in my 74 Satellite and came here to see if anyone had a video about how to get the dad-burned thing to come apart. LOL! Many thanks!
@musclecargarage8882
Жыл бұрын
Thanks and glad it helped u
@HalJalikakik
2 жыл бұрын
Replacing my Challenger steering box and when I pulled it off the rag joint (coupler) was not only in rough shape both shoes were split in half!! I bought a new rag joint and the internals from Tony D'Agostino. Super video by the way. Helping a lot!
@musclecargarage8882
2 жыл бұрын
Oh wow it was that bad.Thanks glad the video helped.
@linzbach
3 жыл бұрын
Good video, covered exactly what I needed to know. Nice job. Thanks!
@musclecargarage8882
3 жыл бұрын
Thanks glad it helped
@matsgranqvist9928
3 жыл бұрын
The reason for the marking on the socket is because there is a master spline and only goes on one way, makes it easier to do it in car
@musclecargarage8882
3 жыл бұрын
You are correct
@danpatterson8009
3 жыл бұрын
Hah! Love these little tidbits that I usually figure out only after trying all the wrong ways. Thanks for the vid.
@musclecargarage8882
3 жыл бұрын
No problem glad it helped u
@JadEDBRAND
4 жыл бұрын
I’ll snap a photo of the entire column I have to see if they are still attached. I’d like to say no we may have utilized them
@johnrosado9245
4 жыл бұрын
Where did you get these parts from? Please add a link
@musclecargarage8882
4 жыл бұрын
Here you go www.ebay.com/itm/Mopar-74-76-A-B-E-Body-Steering-Column-Coupler-Column-Rebuild-Kit-3-5-DMT/362679847203
@danielkuchenberg7046
3 жыл бұрын
Gravity is not going to hold the seal retainer. It will pop up and dirt and moisture will get in and destroy all of your good work. You need to work on that retainer and get it right. There is a spring clip that you can order that will hold the retainer down. You can install it with the column in the car.
@musclecargarage8882
3 жыл бұрын
You are right and I got the spring retainer to fit right everything is good now
@marvin5620
2 жыл бұрын
So after all that you didn't use the supplied aftermarket clip to hold the cap on the unit. That wire clip was an upgrade to hold the cap on that you were complaining about the design of. Geesh.
@musclecargarage8882
2 жыл бұрын
😆 i got it on later. Everything i record im doing at that moment most times
@marvin5620
2 жыл бұрын
@@musclecargarage8882 I got ya. But you've had over 2 years to edit in that part.
@musclecargarage8882
2 жыл бұрын
Dam didn't even know its been that long
@JadEDBRAND
4 жыл бұрын
I HAVE A COLUMN IN EXCELLENT SHAPE U CAN HAVE FOR FREE . I CHANGED TO TILT
@musclecargarage8882
4 жыл бұрын
Thanks and cool. Do u also have steering column studs and nuts that hold up the steering column to the dash??
Пікірлер: 21