I have a 2gc on my boat engine (chevy 3.8) It's been about 2 years since refurb so i may be due to change mine out also, did you do a vidoe fo the swap out procedure for the needle and seat?
@dailyolds1970
Жыл бұрын
Needle and seat is super simple. Disconnect the linkage for accelerator pump and choke if you have one. Then pull the 8 screws out of the top of the carb and pull it apart. Remove the float pin and use a large flat blade to remove the seat. Make sure a new steel crush washer goes under the seat.
Пікірлер: 2