Boy I sure was in love with the look of the 1984 model in that year I wanted one so bad..had a 81 model but was outdated by that point..the kx set the standard for sure that year
@Workerbee-zy5nx
Жыл бұрын
I had an 84 like thst one and it ran great.
@shaunmitc
5 жыл бұрын
That 84 yz 125 was my first bike
@oreng_gunungid
Жыл бұрын
Amazing bike bro🙌🏾
@sheeznutz2254
4 жыл бұрын
I had a 1984 yz 80 and I lived on that bike! I'd duct tape a 9 volt flashlight to the front fender and ride it 10 miles to my buddies house at night! I raced many bikes including a buddies "built" Kx 80 and nothing could touch me! By the way! My yz 80 was bone stock!😂
@fernleytire
4 жыл бұрын
Love the bike, Practice standing up, you will be much faster. Good job
@saltybastard9037
2 жыл бұрын
As much as everyone HATED these '84 YZ125s, I actually loved the way they looked and felt in the corners. I take it you put the '83 cylinder on it, because that thing seems like it rips now. Especially on top, where it was usually DOA.
@schoff-ne2vc
2 жыл бұрын
Nah man in that video I'm just running the standard 84 set up but with boyessen reeds, it's now got an 83 top end jetted to perfection with an 85 pipe & it revs like mad. 👍
@saltybastard9037
2 жыл бұрын
@@schoff-ne2vc It sounds like it runs pretty good for a stock '84. Most seem to run weak up top, where that one seems to keep ripping. Are you just using the stock '85 pipe or an aftermarket unit?
@schoff-ne2vc
2 жыл бұрын
At first it did run pretty flat on top as though it was starved of fuel, so I rebuilt it & made sure the power valve was set spot on & just fitted a set of reeds then it ripped.... Next came the 83 cylinder with the 84 carb and a PSI pipe but the bike now runs & revs better with the smaller 83 carb & the 85 stock pipe. Timming is advanced slightly & the airbox drilled out. It's also now in the European colours. Check it out its the 1st short video on my account.....
@saltybastard9037
2 жыл бұрын
@@schoff-ne2vc I may have to pick up another '84. I was tempted to use an '82 engine, as they were rippers, but apparently there's too many differences in parts to justify it compared to just swapping to an '83 top end set up. I dig yours though. Kudos.
@schoff-ne2vc
2 жыл бұрын
I was also going to go down the 82 route, the porting is identical to the 83 and its the same carburetor. Think it was down to the 82 pipe, in yamaha's wrench report for the 83 it states a number of mods & one of those is to fit the header pipe off the 82.... if I come across a decent 1 I'll have ago at making it fit.
@TheSwagermeister
6 жыл бұрын
Getting the same bike very soon,is it atleast fun to ride a track ? Alot of people say this bike wasnt good
@ralphbruno8611
2 жыл бұрын
84 was a bad year for yamaha.put a 83 top end on it.
@schoff-ne2vc
2 жыл бұрын
It sure was so I've done that modification also running it with an 85 header pipe. Checkout my video of the bike now its red & white.
Пікірлер: 19