Enjoyed the plastic repair and moulding.. I have 2 small cracks on my ZXR H2, left rear panel below the key hole for the seat hump, and a very small crack right in the front/middle of the seat hump. Both are typical crack areas for ZXR’s unfortunately, 80s & 90s panels are pretty brittle now due to age. Nice work 👏🏼
@true-moto-resto
Жыл бұрын
Thanks for watching and commenting. yea the plastex product works really well for that type of issue. I have used the clear powder on stuff like that, put metal tape on the outside of the paint work. pressed down really tight so the plastex cannot seep onto the paint, v groove the back side and applied the clear plastex. worked well.
@lornetontegode6986
Жыл бұрын
Another enjoyable video. It's nice to watch others do the same work and always great to get some tips. I wish I could share some of mine but I haven't started doing videos yet. I share lots of photos on Facebook though. When I did my VF1000f wheels, I stripped the paint off with heavy duty stripper so it was bare aluminum and then acid etch primed and painted then 2k clear. Came out great.
@true-moto-resto
Жыл бұрын
Thanks Lorne, I may try some stripper on the front wheel, there is a pile of clear coat on there that has to come off.
@langdonfairchild1st805
Жыл бұрын
Like the casting for the lug. Not come across that before but will be taking a look now. Another opinion is 3d printing but at a cost.
@true-moto-resto
Жыл бұрын
Thanks for watching , yes the plastex works really well. 3D printing would work too, but I don’t have one of those so I have to do it old school style.
@langdonfairchild1st805
Жыл бұрын
@@true-moto-resto I am old school 🙂 and find your restoration very interesting on different way's of adapting to get the same results.
@true-moto-resto
Жыл бұрын
@@langdonfairchild1st805 cheers!!
@MirchiBoy
Жыл бұрын
Great video as always. Have you attempted pin hole repair on any of the gas tanks? I have that job pending on my ZX1000B2. Edit: I just heard you mention it at the end of the video 👍
@true-moto-resto
Жыл бұрын
Thanks! and ,Yes Sir !, just did the tank yesterday. Episode 6 will be dedicated to the tank pin hole repair.
@steveguest8028
9 ай бұрын
What do you replace that factory foam with on the inside of the fairings ?
@true-moto-resto
9 ай бұрын
I did not replace the foam.
@mike87stanger34
Жыл бұрын
Great video's! I have two 98 zx-7r, love them. Where in northern Ontario? I'm located along Lake Erie.
Пікірлер: 14