Thanks for the great Video very thorough am going to try mine in a few weeks
@dwaynemcmullen8285
Жыл бұрын
On of my more annoying fixes on my xj but fixed my leak
@joshuatree1886
Жыл бұрын
JJ you sure do know your way around a car.
@morgancure1604
25 күн бұрын
If you'd turned the wheel hard left the pan falls out
@kokocloock
13 күн бұрын
Thank you 😂this worked too well I’d been struggling to get the pan past the bell housing on the trans and then I turned the wheel and jacked up the car and the pan was lower than ever
@evansrcandoutdoor7940
Жыл бұрын
Dude you really should have used that plastic guide Fel-Pro provides, the block scraped a good amount of the top edge of the seal off when you were putting it back in, the guide keeps this from happening.
@jjsdiygarage1267
Жыл бұрын
Just the part of the seal that the instructions tell you to sand or cut off. No issues so far, after a few thousand miles.
@trueroyston7791
2 ай бұрын
Question, is there any difference in the regular 4.0 and the high out put one? Mines a high out put and same year as yours and getting ready to do the rear main but I wanna make sure if anything’s different
@jjsdiygarage1267
2 ай бұрын
Not that I know of..mine was a "high output" also.
@streetvictory9411
11 ай бұрын
Was that torque on the bearings in/lbs or ft/lbs?
@jjsdiygarage1267
11 ай бұрын
Ft lbs
@Dreaming-kf4lw
5 ай бұрын
How long did that take you?
@jjsdiygarage1267
5 ай бұрын
About 3 hours... depends on how much time you want to put into cleaning
Пікірлер: 14