Thank you for taking the time and effort to help us 🇺🇸 work and fix our jeeps 😊 the salvage yard wanted to buy my jeep for 200.00 dollars, but a mechanic shop wanted 2000.00 for labor only. I am disabled and 63 years old, i have accumulated all the parts and special tools for to complete the installation process for 500.00 dollars, thank you for helping me with knowing what I need to do...Willis Luckey ...👍👍👍⚡⚡⚡🏁🏁🏁🇺🇲🇺🇲🇺🇲
@jnamemoption7742
4 ай бұрын
Word to the wise; tighten the pinion shaft lock bolt before loosening it. That bolt tends to break upon removal. By tightening the bolt slightly any bond between the bolt, carrier, and pinion shaft will be reduced and then the bolt will be less likely to snap off into two pieces. Unless broken bolt screw extractions are your thing then this little pro tip may save time and money..
@BurnerJones
3 ай бұрын
Thanks, I have a bit of a roaring noise that is really noticeable with the back seats down. Hoping it isn't the pinion bearing, I'll try this first.
@doc5081
Жыл бұрын
Good stuff. You think the wheel spacers caused undue stress on that bearing? Im considering pushing mine out an 1". Thanks, stay well
@dillian6669
5 ай бұрын
Heey little question, i need wheel bearings I had two options to buy the bearing you show in the video but i could also buy taper bearings. Are your bearing the only type fitted? I have a an 98 ZJ dana 35. Wich looked like the ones i need.
@zbyneksurovec
3 ай бұрын
What rear-end is this? Dana 35?
@kyledonahue33
7 ай бұрын
when you put the diff on dont you get a bunch of silicone in there? and do the bearings not need to get packed with grease?
@murraysullivan5368
7 ай бұрын
The bearing is lubricated from differential fluid down the axle tube
@tjsmountaingarage1613
7 ай бұрын
The silicone will squeeze out the side a little but not enough that it will get mixed with the gear oil. Just lay on enough to get a good seal and that's all
@patrickm-bmx9093
Жыл бұрын
Shouldn't the bearing get packed with grease?
@murraysullivan5368
7 ай бұрын
The bearing is lubricated from differential fluid down the axle tube.
@johna.copelandiv8339
Жыл бұрын
I wish to replace my rear pinion in my differential
@user-du3ml4pm6j
Жыл бұрын
How many inch mentioned in the 5:8 min??
@tjsmountaingarage1613
Жыл бұрын
12 point, 1/4" closed end wrench
@randywall9230
Жыл бұрын
Please don't hammer with your hands, your carpal tunnel says that is what hammers are for - otherwise great video good info
Пікірлер: 21