Dude if you just wanted to show your bike off go to instagram. This video is pointless & a complete waste of time
@ak9784
3 жыл бұрын
Thanks for the video man i have a ZX-9R myself, I have a problem when I ride the bike and it gets to its normal temperature around 90C so when its warmed up good when i want to give it max gas around 8000RPM the bikes loses strength it makes a wierd noise like something is.blocked and the bike doesnt go that fast, but when the bike is cold it goes normal i have no problems or when its warmed up but i always switch to the next gear around 8000RPM i also can ride it normaly, what could it be is that a vaccum leak fuel leak or something else would appreciate your feedback thanks!
@thepursuit844
3 жыл бұрын
My first thought is that it could be a carb sync or jetting issue. Have you played around with either? Any mods?
@ak9784
3 жыл бұрын
@@thepursuit844 no I never did anything around the carbs, but i want to take them off and clean the carbs and the jets maybe that helps i hope i dont damage something it will be my first time to take off the carbs and clean them
@thepursuit844
3 жыл бұрын
That is always a good place to start. Clean them up really good. I’d recommend a rebuild kit. You can get them from any bike shop. After they are nice and clean i’d recommend syncing them. Then ride and see where it is but knowing that you have a good baseline to start with. I have a syncing video too.
@ak9784
3 жыл бұрын
@@thepursuit844 thanks man, i will try
@nerdsofthefist
11 ай бұрын
Yeah. I cleaned my carbs just to get my 2000 zx9 to start up again. Had been sitting for 11 years. Then replaced the gas and air filters. I’m guessing this is the next thing I need to do because even after it’s warm, I can pull in the clutch to turn or stop and the bike just cuts out. So.. I don’t know haha. But my point is, if I can clean the jets, you can. Type in “tweed zx9r crb cleaning” and you should get the video I used.
@JRuse-bv3hz
21 күн бұрын
Melt
@lukaszsikora849
2 жыл бұрын
Where to connect vacuum hoses?
@headstill
Жыл бұрын
WTF??? CLICK BAIT WASTE OF TIME!!! If you are going to talk about a serious maintenance item on these old bikes then show us what it takes...total BS.
@thepursuit844
Жыл бұрын
This is the final video on this bike with a simple carb sync. Please go and check out the other videos on this bike if you are interested in seeing more.
@motocitaly3835
2 жыл бұрын
What exactly I have to reassure when Starting my zx-9r after 6 months, please tell me the things I need to check before hitting the roads, sometimes my bike feel power less moreover something resisting the throttle
@thepursuit844
2 жыл бұрын
Good question. There’s no right answer but here is what I do. Put fuel stabilizer in the tank and run it for a while before storing. Change the oil and filter. Plug the battery into a tender. Then before riding it again I check things like tire pressure, oil level, coolant level, chain tension and do a general once over of as i’m cleaning the dust off.
@motocitaly3835
2 жыл бұрын
@@thepursuit844 thanks a lot and can you tell me which parts I have to change for longer life span and the parts must me affordable
@thepursuit844
2 жыл бұрын
Spark plugs, chain and both sprockets as they wear, coolant flush, etc, treat it like a fancy car and give it a maintenance program.
@1984jonnyjc
3 жыл бұрын
Dove hai collegato i tubi dei vacuometro?
@thepursuit844
3 жыл бұрын
I’m sorry. I only know english. Translator gave me “where do you connect the vacuum gauge tubes?” There is a vacuum port for each carb between the carb and motor. Two have vacuum lines attached and two are plugged with bolts. C'è una porta del vuoto per ogni carburatore tra il carburatore e il motore. Due hanno linee del vuoto collegate e due sono tappate con bulloni.
@1984jonnyjc
3 жыл бұрын
@@thepursuit844 potresti mandare delle immagini perche in tanti video che ho guardato non si vede bene
@thepursuit844
3 жыл бұрын
Ho caricato un video mostrarlo.
@veloxrevolution1
6 ай бұрын
Hello , I have the same motorcycle and I can't find the vacuum gauges to synchronize the carburetors? Where to connect the vacuum hoses to the carburetor? It would be a great help if you answer this question for me. Thank you and greetings from Germany.
@thepursuit844
5 ай бұрын
@veloxrevolution1 i bought mine off amazon. There is one port per carb which has a cap on it.
Пікірлер: 27