Slightly different on my 2.3 Tacoma but the system is the same using a nut and allen key. Had a low idle that was stalling out. Now it's perfect. Thanks a mil.
@craigphillips1047
Жыл бұрын
Glad it helped!
@jeffburgess7691
3 жыл бұрын
I just replaced mine it helped
@johnmuniz14
3 жыл бұрын
Have you had any problems with having the rpms of the vehicle idle up and down dramatically only while at a stop?
@craigphillips1047
3 жыл бұрын
I have not; sounds like the IAC or maybe a vacuum leak. Those vacuum leaks are hard to find unless they are really big; spritzing water is a good way to find a vacuum leak. I installed the throttle body gasket upside down and had a big leak and it ran like trash!
@mehrajful
3 жыл бұрын
What is the name of the thing 1:41 the plunger where you pulled? and how to adjust it's gap? Thanks
@craigphillips1047
3 жыл бұрын
It is called the throttle opener. The service manual says to disconnect the hose on the left which will keep the open fully extended which keeps the throttle body slightly open. The engine rpm should be between 1,200 to 1,500 rpm. I do not think it is adjustable. I only adjusted the bolt that would effect the throttle body minimum position once the engine is running. I’ll go take a look later and see if the opener is adjustable or if it can be replaced without replacing the whole throttle body. Send me your contact info if you want a page out of the service manual.
@morphius747
9 ай бұрын
ever figure out the problems?
@ranaishtiaq275
3 жыл бұрын
Hi, how much should be the distance between throttle and Air sensor
@craigphillips1047
Жыл бұрын
If you still need this I will go measure, I would be curious what the stock position is... I can go look in the manual.
@LaClika503
11 ай бұрын
Mine chops like it has a cam then it settles down smooth then bogs when I take off, but then doest do it after a Drive and stop and go, idk anymore
@AD-kq2nx
4 ай бұрын
Any luck? Mine is choppy off the start and doesn't stop.
@yotagang3705
3 жыл бұрын
i have rough idle at red light in D, everyone tells me not to adjust that
@craigphillips1047
Жыл бұрын
I don't believe that is the intent of the set screw and yes we are probably masking some other issue. This truck has always shook in "D" at a stop but recently (last 7 years) it has been really bad. I'm going back to stock motor mounts and seeing if that is the issue. From the way I see it we are just setting the resting point of the throttle. It starts with it at a more open position to get a lot of air in on startup but once it gets compression it pulls the diaphragm back and rests on that set screw.
@craigphillips1047
3 жыл бұрын
Hit me up on any questions you have!
@SFGMOB
3 жыл бұрын
Hey mine is mostly stock but for some reason it crackles and pops on decel and if I hit the limiter it sounds like gunshots going off, not sure if I should be concerned as to why my engine is dumping gas into the exhaust
@aaronpoznick6785
2 жыл бұрын
hey Craig I have a 1998 Toyota 4runner with the 2.7l, right now I'm having an issue were I cant accelerate past 3000prm with out the motor sputtering and missing, I've done maf sensor spark plugs coils and wires, i recently replaced the fuel regulator and plan to do the fuel filter, (mine is located under my intake manifold), if you have any ideas i would be really thankful, I've been restoring this for my family
@Alpha_Wolf.
11 ай бұрын
@@aaronpoznick6785did u have any luck solving the issue?
Пікірлер: 19