Been nice to have the part number in the description. Thanks for posting. I appreciate it.
@aaronhogan2371
Жыл бұрын
Protip: make a match mark on the optical trigger wheel before disassembly indicating the right way up. Protip #2: there is a second (hidden) crank angle sensor on certain models fitted with vg30e and vg33e engines located behind the cylinder head. Remove heat shields to find it. Hope this helps you when you find this comment :)
@OverlandPNW
3 жыл бұрын
Nicely done! You are more mechanically gifted than I am !
@cptpackrat1
3 жыл бұрын
This is a super easy process that anyone can do!
@PsiFire1
3 жыл бұрын
I am ashamed that it is this easy and I didn't do mine sooner. Thanks for the video Cody!
@gacastillo21
3 жыл бұрын
Awesome! Thank you for the video! I will be doing this on both of my 2002 4x4 Xterras.
@zmoorer
9 ай бұрын
I believe what you are calling the 'crankshaft sensor' is actually the camshaft position sensor. Do you have a part number for the camshaft sensor?
@zmoorer
9 ай бұрын
I was getting p0340 camshaft sensor. I took the dizzy apart and found metal shavings inside. Is it possible that i only need a new bearing and not the camshaft sensor as well? Only 130K miles on my 2000 Pathfinder.
@thewayjesuschristislord3700
10 ай бұрын
Where is the cam shaft sensor
@watari4807
2 жыл бұрын
Nice video tutorial, did the bearing replacement solves the cranking no Start issues or still have to replace the ignition coil ? My car will crank but will not start the engine , found the bearing missing couple of roller ball . Thank you
@scottyfixer452
3 жыл бұрын
Awesome vid. Did your sit flush when. Installed in the vehicle. My 02 Xterra distributor doesn’t want to sit flush or bottom out when installed in vehicle
@thewayjesuschristislord3700
10 ай бұрын
Do you mean the cam shaft sensor not the crankshaft sensor
@bbear3763
Жыл бұрын
Are most of the screws the same size? If not how the heck did you rememer which ones went where?
@quentinmontoya2559
6 ай бұрын
How did u get the rotary off? Your video starts with it off? Thanks.
@cptpackrat1
6 ай бұрын
Its just pressure fit on and then uses a screw yo keep it held in place.
@damian2455
Жыл бұрын
Is 6000 2rs good bearing?
@johnross9350
Жыл бұрын
Instead of using the outer race and distributor housing to press that 25 dollar bearing on the shaft and risking destroying it and the housing use a press by doing the way he says your definitely shortening the life of that bearing
@cptpackrat1
Жыл бұрын
Yes and no. I understand what you are getting at, I have rebuilt several distributors this way and they have all lasted over 100k miles. The very first one I rebuilt was rebuild around 120k and it honestly never needed the rebuild. Bearing still felt perfectly fine. Also, you can get these sealed bearings for about $8 if you shop around a bit
Пікірлер: 18