Great video, explaines alot, I have the same code, so I replaced my solinoid pack and the codes are still present with limp mode....I will check my wiring to the transmission to see where there may be a break, thanks for posting !!!!
@5aldl
14 сағат бұрын
What is the update regarding your wiring?
@bksteele418
4 жыл бұрын
Great post!!! Having the same issue. Works great for 10-15 min then back to limp mode. I'll keep ya posted Boss!
@mbdagoat3709
3 жыл бұрын
Just ordered my solenoid and speed sensors. Was going to take my 00 intrepid to the shop but since seeing you video last night I am going to check in a few minutes to see if this is whats the problem. I have the same fault codes. I'm thinking I to the she problem. Be back in a few to lyk
@wesleybackfisch4050
7 ай бұрын
Hey I know this is an old video and was wondering if anyone would reach out here. Kind of a long story buuut, I’m a new driver, have a little mechanical knowledge behind me but I went to go and get my 2.7L 2001 dodge intrepid SE registered and as I was going down the highway the ABS light came on, thinking that was weird cause I didn’t feel the abs at all I kept going cause I had a hill coming up, so I slowly pressed on the gas and the rpm’s went up to 3500 but no acceleration, was going 50 and it was dropping fairly fast, pressed the gas again and it did the same thing, no acceleration. Pulled off on the side of the road and turned the car off and my hose that goes to my purge solenoid I think, it’s got two hose one that trails back to the evap canister and the other going to the upper intake in front of the throttle body. The two hose were like zip tied together, they got too close to the exhaust manifold and absolutely got greased. Hooked up a scanner and it popped up P0700 Transmission Control System (MIL Requested) no other codes, just P0700. Could you help, had the car for a few months did some work to it. Also could a high rpm at idle cause this? My cars been doing that after I changed valve cover gaskets and upper intake gaskets as well as spark plugs. Please HELP.
@Mounier777
7 жыл бұрын
im getting those two same codes on my 2006 pt cruiser......i changed the speed sensor and the transmission solenoid and still have the same codes
@SuperDjnrg
7 жыл бұрын
Mounier I have some info for you, look at your harness . look after the O2 Sensor connector on the vehicle side and feel if there's a rubbed through spot grounding near the head. I found it on a Dodge Neon and it's the same set up. if you have a scanner you could see the o2 sensor is not working properly. hope this helps.
@SuperDjnrg
7 жыл бұрын
Mounier check your harness where it drops down from the corner of the head,neon and cruiser are known to rub through the protective coating there.
@jeanparish9559
7 жыл бұрын
Gilbert Galvan, I too have been getting the p0700 code, but instead of the accompanying 0750 that you were getting, I'm getting a 1776 with the 0700. I've been going through the same process with getting the shift control module, then having to stop and ask myself, "what about the L/R solenoid itself? How do I check the L/R shift solenoid? And without dropping the whole trans valve body? I feel like I'm going down a rabbit hole with this issue. It would be great if it was just an over heating wire. Have you ran across the 1776 accompanying code online? I haven't had much luck. I'm going off on my innova scan tool.
@SuperDjnrg
7 жыл бұрын
Jean Whicker-Parish I will look into it, the only problem is that all your solenoids are all clustered together. Can't change one without changing all of them. Give me some time to review the code.
@jeanparish9559
7 жыл бұрын
Thank you Sir, I very greatly appreciate your time and help!
@bableroybrown1
4 жыл бұрын
Did the 2000 intrepid shift lock up "
@SuperDjnrg
4 жыл бұрын
I dont understand your question.
@shelbymorning9845
4 жыл бұрын
Hi I have 2 code the P0700 and a P0871 code. My transmission fluid is full and my car doesn’t seem to have any issues shifting. Any advice?
@SuperDjnrg
4 жыл бұрын
Is it the same car as in the video or different?
@Lunded68
9 ай бұрын
I have a p0700 and p0871 Did you find the issue on your car?
@calidronelife1572
7 жыл бұрын
Great video bro well done. I have a 2002 Intrepid with the code P0700 P0740 HELP!
@SuperDjnrg
7 жыл бұрын
Jonny P what have you done to your car so far?
@Courtney22Lee
5 жыл бұрын
Can I get an update on this? My boyfriends 2002 interprid is throwing the same codes. Anxiously awaiting, Court❤
@cm7884
4 жыл бұрын
What kind of coder do you use?
@SuperDjnrg
4 жыл бұрын
BLUEDRIVER.
@neiahsworld8136
5 жыл бұрын
Hi i have a 03 intrepid has engine light on
@SuperDjnrg
5 жыл бұрын
Did you pull codes?
@neiahsworld8136
5 жыл бұрын
@@SuperDjnrg p0700..thats all
@SuperDjnrg
5 жыл бұрын
@@neiahsworld8136 did you check to see if your harness was fused in the same spot mine was?
@SuperDjnrg
5 жыл бұрын
Also what kind of scan tool are you working with?
@neiahsworld8136
5 жыл бұрын
@@SuperDjnrg im not sure which spot other guys are saying its this and that im sure..just like you said its a worn or exposed..fused wire but im not sure where...
@iwin2052
3 жыл бұрын
I have the same car what a piece of shit I hate dodge and will never get another one all they make is junk only 88k miles on it to.
Пікірлер: 28