thums up for the injured finger ...brothers in arm
@ProZacksProjects
8 ай бұрын
Hahahahaha
@jharuni
Жыл бұрын
I want to give you a thumbs up for a great video but man, blowing half that crud all into the car and then lifting the old pump off with most of the crud still on it ??? So 2 days later the new pump gets clogged with mud? All you needed was a wet rag. Great tutorial otherwise.
@ProZacksProjects
Жыл бұрын
It’s a lifetime pump so I’m not worried. 😉 jk there actually wasn’t that must loose debris on top but that is an important thing to have on hand.
@yakicahoon1605
2 ай бұрын
Thimbs up for the injury bit 3 hours of banging later & it still hasn't moved a tiny bit
@dakotadeansypolt2889
27 күн бұрын
Waste of time making this video absolutely terrible
@charliehos3936
Жыл бұрын
Next video; how to get dirt and debris out of fuel lines and tank!
@ProZacksProjects
Жыл бұрын
Hahahaha exactly
@thesammibroomi
2 ай бұрын
Hows the Carter brand pump doing 2 years later? I see the same one on RockAuto but have never bought any of their other parts.
@ProZacksProjects
2 ай бұрын
So far it’s holding up good. I buy quite a bit from them just because they have great prices. It’s an option if you need to go that route.
@avkarlos
Жыл бұрын
Thanks you i save like 600 dollars for this 👍👍
@gregdrew874
13 күн бұрын
Nice, simple informative vid. 👍
@EagleNestApiaries
2 жыл бұрын
What was the brand on that wooden screwdriver? I have the same one.
@ProZacksProjects
2 жыл бұрын
I’m not sure but I hear they’re not very poplar.
@simonburns1055
11 ай бұрын
I like your special service tool lol
@gevans5446
6 ай бұрын
Yeah, do you have the part number for that one?
@originalmachine85
2 жыл бұрын
Can you provide the part #, where you found it, and the price? How long will the new one last?
@simonburns1055
11 ай бұрын
Tip: dont loose the yellow clip
@Blighted_Ashes
5 ай бұрын
Could this be why my 06 is running lean? I changed the MAF already.
@ttowndweller9670
8 ай бұрын
How do you know this needs to be replaced? I have 2006 corolla cranking with not start?
@ProZacksProjects
8 ай бұрын
Pull the rear seat and when you turn the key on you should hear it buzz as it pressurizes. If it’s silent then it’s dead.
@ttowndweller9670
8 ай бұрын
@@ProZacksProjects Thank you kindly!
@jonathannoblezada7796
Жыл бұрын
Was the filter in the pump housing? What part # and where did you get yours? Good diy vid. Thanks
@Asimrafaq
Жыл бұрын
He changed complete unit which includes fuel pump fuel filter, fuel gage assembly and complete housing . That costs around 60 $
@ProZacksProjects
Жыл бұрын
I bought the Carter fuel pump assembly from Rockauto.com for ~$158 the part number is P76578M
@Ajst1987
7 ай бұрын
Straight to the point! Subscribed!
@ProZacksProjects
7 ай бұрын
Thank you, I try. 😁👍
@antoniop5889
Жыл бұрын
What were the symptoms of it going bad??? Mine won’t start on the first try always on the second.
@ProZacksProjects
Жыл бұрын
It just died while getting on the highway.
@GillyTech
Жыл бұрын
@@ProZacksProjects How many miles was the car at before the pump died?
@ProZacksProjects
Жыл бұрын
@@GillyTech I believe it was around 140k
@GillyTech
Жыл бұрын
@@ProZacksProjects dang, I’m overdue.
@intelin123
7 ай бұрын
Bad fuel pump will idle fine but as soon as you put it in drive it stalls sputters and dies.
@baykay9559
2 жыл бұрын
EXCELLENT VIDEO! Just the tutorial I needed. (Knuckle busting at its finest lol.)
@ProZacksProjects
2 жыл бұрын
Haha yes. Nothing like your car leaving something to always remember it by.
@khacker7345
2 жыл бұрын
Never forget trying to break loose a chevy rear end cap, I busted the tool, and slammed my thumb, right into the seam of the gas tank. Mashed my thumb between the long handled wrench and the metal lip of the seal. For the next month I was using 2 fingers bent, to hold a bolt and start it into the threads.
@ProZacksProjects
2 жыл бұрын
@@khacker7345 that’s rough!
@granden2077
3 ай бұрын
Thumbs up just for using the Wooden Persuader instead of trying to get the ring tool on short notice. 🍻
@chichiorlando
2 жыл бұрын
👍🏽💪🏽💯Awesome Video
@johnkaney1051
Жыл бұрын
I had to stretch the gasket out a little so it would stay put. It works but now the gas gauge is stuck at 75 percent.
@ProZacksProjects
Жыл бұрын
Oh that stinks!
@nigelpatrick-fi3cn
Жыл бұрын
thanks
@niacal4nia
Жыл бұрын
Ok to pull the fuel pump fuse instead of negative battery cable? I don't have my radio codes.
@АндрійЗадулий
9 ай бұрын
Guys, I can't unscrew the lid, I already bought the key. The ribs break and the lid doesn't unscrew. Who had this and what did you do?
@ProZacksProjects
9 ай бұрын
Have you tried tapping all around the top to try and break loose whatever is holding it?
@JacobRaid-w2y
Жыл бұрын
you make it look so easy reality you break all the tabs🥲
@ProZacksProjects
Жыл бұрын
I actually didn’t break the tabs.
@thomasmcleish4246
3 ай бұрын
@@ProZacksProjects I cannot get it to move even with a small sledge hammer and wood. I tried with a metal and a metal piece but it just broke the tab.
@TiagoNevesNET
6 ай бұрын
... probably should NOT do this on a full tank, lol
@ProZacksProjects
6 ай бұрын
Probably……. But necessity may dictate otherwise.
@mosampson8862
8 ай бұрын
You're not doing it right unless the blood comes out.
@ProZacksProjects
8 ай бұрын
😂
@godzilla0974
Жыл бұрын
No blood no foul
@GillyTech
Жыл бұрын
There is actually a wrench tool that is for removing that big plastic ring but it’s $50 minimum 😢
@Anthony-qw6xk
Жыл бұрын
And it works like a 5.00 tool. Pretty much useless
@GillyTech
Жыл бұрын
Good to know
@eyyo2561
Жыл бұрын
Awesome video
@ProZacksProjects
Жыл бұрын
Thank you. I tried to keep it simple
@ladykeez319
11 ай бұрын
I'm definitely about to do this on my mom's corolla
@ProZacksProjects
10 ай бұрын
I hope it goes well. 😎👍
@carmenfarmen9548
10 ай бұрын
I cant get that red clip in tried everything
@ProZacksProjects
9 ай бұрын
It’s very finicky but try using a tiny screwdriver and working the ends.
@fireyourrocketts
Жыл бұрын
This is a good video on how NOT to do this!!!! all that dirt should be cleaned before opening the lid but hey he did it in 5 minutes...must be quite a mechanic!🤣
@ProZacksProjects
Жыл бұрын
I vacuum would be a must for this job. If I had a cordless one then that would’ve been wonderful.
@baileybennett5847
Жыл бұрын
Rumor has it the car never started because he didn’t vacuum it
@ProZacksProjects
Жыл бұрын
@@baileybennett5847 I would’ve but…… my vacuum sucks.
@thomascampbell5633
11 ай бұрын
Very helpful. Excellent camera work shows exactly what you are doing. A real confidence building video.
Пікірлер: 68