Helpful video, thank you! I would also spray clean MAF sensor and Throttle Body, be sure disconnect the battery. NOTE! there are 2 separate spray cleaners: for the MAF and for Throttle, do not mix... ✌
@MattStephensRich
2 жыл бұрын
good tips!
@karlborth455
8 күн бұрын
Ok some electrical contact spray on the maf would do yes
@scottykilmer3920
4 ай бұрын
Let me tell you these aftermarket iacv are not made Oem specific ! Most of them lets the car idle a little higher or a little lower than what it should be. 8 out of the 10 aftermarket brands does not work like the Oem part. And all of them stops working for about 1 year of use.
@mikehawk892
3 жыл бұрын
Thank U! Very helpfull!
@MattStephensRich
3 жыл бұрын
Glad it helped!
@_joshua_g59_90
2 жыл бұрын
Thank you my friend.
@MattStephensRich
2 жыл бұрын
Glad to help!
@samtan7929
3 жыл бұрын
My escape the IAC V is differrent side installed ,if I change new one like yours it should be installed as clip shown?
@MattStephensRich
3 жыл бұрын
It could be you have a different engine size. IAC valves gratefully all install in similar fashion. :)
@highlanderdetroit5370
Ай бұрын
GREAT !!!
@MattStephensRich
Ай бұрын
Thanks!!!
@josemontalvo6576
Жыл бұрын
Tengo entendido que se calibra y no la calibrate?
@charlyegivens3486
Жыл бұрын
Vacuum Solenoid is also a very common problem part. It is the round black part with 6 ridges. Its located to the right of the green air hose connecter you see in this video. it takes 2 screws, but be careful. The seal will fall into the engine compartment as soon as you take out the last screw holding it in. Also, check for dry rotted or split air lines. The part mentioned in the video, and what I mention fixes 80% of these engines that i have come across.
@MattStephensRich
Жыл бұрын
good tips!
@dirkgunify
Жыл бұрын
I have replaced the Mass airflow sensor, the IAC, EGR valve, My escape threw P1504 ans would die every time I came to an idle. I can't find a vacuum leak anywhere. Should I move on to the Vacuum Solenoid? It started doing it again when AC is on. The code never went off.
@MattStephensRich
Жыл бұрын
Ultimately between replacing this and the EGR valve, we had the car engine back at 90% reliable operation. Still had stall problems whenever the car would come off of highway cruising speed to a dead stop. Likewise was never able to pin down the exact cause a vacuum leak or other culprit.
@boomerguy9935
Ай бұрын
When I replaced my EGR valve and vacuum solenoid, I needed to replace the vacuum line harness. Ford lists this as a part but I couldn't find one by Ford or any aftermarket company. I removed the harness from the car, removed the plastic cover, and set it on the workbench on top of a lot of paper towels (the hose disintegrates into dust when you touch it) and then I slowly replaced each section of vacuum hose (all the same diameter), making sure that I kept the angles and attitudes just the way they were originally. Once I finished, I replaced the plastic cover and maneuvered it back into place. (BE SURE TO MEMORIZE HOW IT CAME OUT! THERE IS A TUNNEL.) It works perfectly now and I only spent about $8 for the vacuum hose at the local auto parts store, and I still have some left over.
@karlborth455
8 күн бұрын
So is this the 1 you can adjust up near the firewall
@VAGHolic
Жыл бұрын
Good for u! Mine revs at around 5k RPM
@MattStephensRich
Жыл бұрын
Nice 👍
@terminalvelocity4858
3 жыл бұрын
I have a 2005 Ford Escape and only notice after sitting idle, about every 30-60 seconds the RPM's drop out a bit and then it comes back. Does this sound like IAC or MAF?
@MattStephensRich
3 жыл бұрын
IAC is worth a shot, as it's relatively cheap and easy to fix!
@otarsulava
2 жыл бұрын
Try also CRC MAF sensor spray cleaner and CRC Throttle Body spray cleaner, both cleaners are different, do not mix. Would also change the air filter. I did all the above on my 06 Escape 3.0, it runs / idles like a new... Hope this helps ✌️
@MattStephensRich
2 жыл бұрын
Good ol CRC!
@karlborth455
8 күн бұрын
So did it fix the problem I've got 2001 v6 escape in Australia we've just swapped over engine & it goes great over say 1500rpm but when you drop it down to idle it stops. So hopefully this quick fix will fix the issue
@otarsulava
8 күн бұрын
In the US there are multiple fuel injector cleaners, by far the best I used is Royal Purple brand, I would try that too as long as spark plugs change and air filter, lastly disconnect the battery to reset ECM usually 20 minutes or so, then reconnect and idle run for 15, when start drive within next 100 miles just accelerate gently, no high RPM, I'm sure it will help... Best ✌️
@mateosworkshop5199
Жыл бұрын
So what I understand is that you had a rough idle coming to a stop from a high speed.My escape does exactly that.Normal idle is ok.Something could be smoother. It’s really rough stopping after high speed.Did the iac valve fix your problem? Thank
@MattStephensRich
Жыл бұрын
Yes! IAC did help with curing a lot of the problem.
@mateosworkshop5199
Жыл бұрын
@@MattStephensRich ok great! Thanks for your response
@MattStephensRich
Жыл бұрын
you bet!
@rideout1989
2 жыл бұрын
Did this trip the check engine light?
@MattStephensRich
2 жыл бұрын
Indeed it can if the issue is significant enough to indicate bad air flow or bad air fuel mixture.
@bibbic403
Жыл бұрын
After you put the new one in do you have to adjust the intake ?
@MattStephensRich
Жыл бұрын
No adjustment needed - ultimately air intake is controlled by the engine CPU, which is continuously adjusting.
@bibbic403
Жыл бұрын
Ok. Cause I put new one in. Sounded weird. Than I checked there was only one thing I could find. Turn key to on hold break and gas in for five seconds. Release turn off for ten seconds. Then start. And it sounded better
@MattStephensRich
Жыл бұрын
glad to hear it!
@ThesiKCOne661
Жыл бұрын
was it making a pop noise?
@MattStephensRich
Жыл бұрын
No pop noise, just a lot of engine lugging
@keikopompeii3059
3 жыл бұрын
So I changed the IAC, but the car turned off in park.
@MattStephensRich
3 жыл бұрын
Another part could be the culprit - IAC is a great place to start, but indeed sometime something else is needed for the full fix.
@seeya205
3 жыл бұрын
Very common Ford problem!
@VAGHolic
Жыл бұрын
Nah Every vehicle that has a IAC. Electric throttle bodies don’t have and so this issue is non existent
@z06badboy18
2 жыл бұрын
2012 escape 2.5 liters 4 cylinder where is this thing!!??
@MattStephensRich
2 жыл бұрын
It should still be in the roughly same location, recommend googling to get engine bay schematics.
@sargvision8313
3 жыл бұрын
Is that really the engine
@MattStephensRich
3 жыл бұрын
Sure hope so.
@markamd1
3 жыл бұрын
lol what?
@andyjuarez163
2 жыл бұрын
Where would the IAC valve be on a 2008 for escape 2.3 4 cylinder not a hybrid
@MattStephensRich
2 жыл бұрын
It should be in roughly the same location, recommend googling engine bay schematics to get a best lay of the land
Пікірлер: 52