My 2001 Honda CRV with 131K miles on it is making the exact same noise. Mechanic can't figure out what it is. Did fixing the rod bearings get rid of the noise?
@WilliamJohnson-cz4hy
9 жыл бұрын
Temporarily. One trip on the freeway and it started doing it again. I didn't open it again but, I believe it cracked the new bearing. I suppose a rod was bent so new bearings would just keep cracking without an engine overhaul. In the end I bought a pathfinder from someone who wanted my CR-V for his kid. He had a mechanic throw a different engine in it and didn't bother with the old one. I don't know where he got the engine but, I know they are available barely used from Japan. Sorry, no advice on a fix.
@trainwrecka8953
4 жыл бұрын
Bent valve
@gsscotland
10 жыл бұрын
Definitely a bearing, you can easily find out which one by starting the engine then pull out (and pop back in of course) each HT lead. When you pull the lead out on the cylinder that has the bad bearing the noise will disappear. But be very careful, you can get a shock doing this so it's at your own risk. I've seen others do it fine but they have admitted getting the odd shock sometimes. A common cause for your bearings to go are overfilling the engine oil. When there's too much oil the rods will smash into it and start frothing it up which means you don't just have the lovely lubricating oil in there but lots of nasty non-lubricating air.
@eduardong6553
7 жыл бұрын
had the same problem.... found the number 3 exhaust cam was damaged... i replaced the exhaust camshaft. and engine works smoothly and quietly again.
@WilliamJohnson-cz4hy
11 жыл бұрын
I too a look at the rod bearings and one of them is cracked in half. I'm working on replacing them to see if that was the main issue.
@goodiegood4994
10 жыл бұрын
Replacing the rod bearings fixed your problem? My 2001 Crv do the same noise, when I look at your video it's like I 'm listen to my motor.
@vernoncarcha3598
4 жыл бұрын
Valve clearance or head gasket
@josegonzales9911
4 жыл бұрын
Did you found what it was ?
@tripjet999
5 жыл бұрын
Keeping vehicle (including engine bay) CLEAN will help prevent problems!
@alphanumeric1529
3 жыл бұрын
How? Why?
@maxvancamp245
4 жыл бұрын
its knocking too
@agussupomo4352
11 жыл бұрын
Any update on your clicking noise?
@molexmejia8449
2 жыл бұрын
What was it…?
@edwinw5426
7 жыл бұрын
Was there ever a fix for this issue?
@mrjason9382
6 жыл бұрын
Interesting
@enricoquiniones728
4 жыл бұрын
It does same noise on my honda crv 2000 and the engine block is so hot. Does your engine block gets hot too...
@WilliamJohnson-cz4hy
4 жыл бұрын
Back when I still had this it did not have any overheating issues, only the clicking. I imagine bearing issues could cause overheating, though.
@mrjason9382
6 жыл бұрын
Any one else see green antifreeze
@FuzzyMuzzey
11 жыл бұрын
Did u ever figure out what's wrong with the car? How is the idle?
Пікірлер: 22