Good video, thanks for posting. Lots of potential fault points. Easier than chasing wires for someone new to the bike.
@christopherlykins7311
2 жыл бұрын
Thank u.
@kristyhenry530
4 жыл бұрын
Hey i got a 2002 cbr954 and its doing the same thing. Did your light come on when u turned the key on?
@goldstonsautoshop1228
4 жыл бұрын
Which light?
@djdk42581
4 жыл бұрын
hey thanks for the video. So did you end up replacing the diode and if so where did you order one from? thnk you
@goldstonsautoshop1228
4 жыл бұрын
I made a second video you also need to look at that one because it may not be the diode it may be the wiring harness. Check that first before you replace the diode. And i just order a new ignition and key from Amazon
@davidraybould6987
4 жыл бұрын
Started my bike last time in January 2019 for about 10 min then tried to start it today pump wont prime getting codes 12,13,14,15 they are injector codes tested all injectors they are good all fuses are good all relays are good only thing I haven't checked was the ignition diode do you think that is the prob? .... but why am I getting the codes
@goldstonsautoshop1228
4 жыл бұрын
You always have to make sure the pump is getting power the injectors in these bikes dont go bad too often
@riderzinc
3 жыл бұрын
My bike done this today, Fuel pump won't prime but turns over
@goldstonsautoshop1228
3 жыл бұрын
Check the wiring harness first i went through everything trying to fix it and it was just the wire that provides power to the fuel pump had got to hot and didn't have a good connection
@felipeleon6299
Жыл бұрын
Q me dida es el diodo q lleva
@nestyjimenex7903
3 жыл бұрын
Its supposed to have 9volt on the pink cable not 12 its a signa to the computer. You can use a 9volt battery to fool the computer
Пікірлер: 12