Not sure if you still read these comments but I’m going to be putting those injectors in my 00” celica and I wouldn’t know how to do it without your help! THANK YOU SO MUCH!!
@chasevogt2090
5 жыл бұрын
Thanks so much man I used your instructions to pull off the fuel rail and tighten down that disc and screw thing in the middle and it’s running better now than ever , thanks man
@michaelkemp9358
6 ай бұрын
Do you have to disconnect the car battery to do this?
@gravitycharge
4 жыл бұрын
i removed my injectors from the rails and all my fuel started gushing out lol. make sure to have a paper towel handy if ur lines are pressurized
@doctorfrankenmotor4044
4 жыл бұрын
True. It's a good idea to rub them with silicone grease or even lithium. Choose the blue or orange seals and be EXTREMELY gentle. There's a pressure relief valve inline to the injectors near the fuel filter. Let the pressure out there. But as you said, have some shop towels ready to absorb the fuel when the pressurized gas comes out...
@redtwista
Жыл бұрын
Glad I found this comment. Lmaooo reassuring for sure
@adrianroman9124
Жыл бұрын
Where did you get both gaskets. I can only find the top but not the bottom
@YTkingcherry
5 жыл бұрын
So my check engine is on When I put gas, I turn my car on and then turns off after a few seconds without accelerating, if I drive for a few seconds it will act normal but if I don’t accelerate it turns off You think something is wrong with my fuel injectors n also something it smells like gas
@NeoJSsk
4 жыл бұрын
KingCherry I got that same problem too, did you figure out how to fix that?
@doctorfrankenmotor4044
4 жыл бұрын
So sorry I haven't been very active. Personal issues have kept me from my channel for a long time. I'm sure by now you've either gotten rid of the vehicle or had it repaired. It sounds to me that you have an an EVAP problem. Meaning the sensor in the fuel tank is reading low pressure. That could be anything from a bad gas cap seal to a leak in the fuel filter neck to a fuel pump that's not seated properly. For those with similar issues, you can go to almost any parts store and have the codes read for free...
@raffymytaffy
7 жыл бұрын
My ingectors are leaking on my Toyota Celica 2000, and whenever I start it gas just sprays out. would it be because of the seals then also... Was thinking of taking it to a mechanic. But would it be cheap and maybe and easy to do.. hopefully it's the only problem.
@doctorfrankenmotor4044
6 жыл бұрын
First of all, I'm very sorry for taking this long to respond. My suggestion would be to buy a set of injector seals. They are very easy to install. But you have to be very careful with them, because they tear easily. Lubricate the seals with silicone grease if you can. Just make sure they aren't dry when you push them in. Go gently turning them right to left. Remember you have both bottom and top seals. Ease the top ones in first, in the fuel rail.
@injectorplanet4306
6 жыл бұрын
any amateur mechanic can accomplish, and its true a simple rebuild fixes most issues. for Genuine replacement fuel injectors / parts for your Toyota please check us out on the link below www.injectorplanet.com/collections/lexus-toyota-fuel-injectors awesome tutorial thank you -Bryan
@llugo9399
3 жыл бұрын
What size is the smaller o ring?
@thenewjohnathon33
2 жыл бұрын
Nice
@rf6965
4 жыл бұрын
How do you know which cylinder is 1?
@doctorfrankenmotor4044
4 жыл бұрын
Generally number one is the cylinder closest to the crankshaft pulley. Number four is closest to the transmission. Meaning that in a transverse engine, (one that's in there sideways, typical of front wheel drive on a Toyota), the number one cylinder is going to be the one on the left if you're standing in front of the car. It's the first one on the passenger side.
Пікірлер: 17