Absolutely love your approach to this problem. Thank you for not ordering the $600 Fuse box to fix one relay. You give Mechanics hope that there are good people left in your industry!
@ACEV-zm5yb
Жыл бұрын
ONE OF THEE BEST DIY TUTORIALS IVE EVER SEEN..!! Love the music aswell. For real good job. I never comment on things but the awesomeness of this video made my day.
@joshstacy623
2 жыл бұрын
I might to have to have this done. Getting ready to test the relay in a few. I saved the website you put in the description
@woodrooowoodrooo1709
2 жыл бұрын
Please let me know the outcome... I'm having issues as well with crank, no start.. Thanks
@khalidkfy7368
3 жыл бұрын
Excellent job
@nate8895
10 ай бұрын
I performed this fix, and it was pretty easy if you have even minimal soldering experience
@joediana5055
9 ай бұрын
And also what size tip is recommended to use for the desoldering tool.
@jtr499
2 жыл бұрын
I have a no crank situation on a 2004 Navigator. There is no continuity from the start relay load terminal to the starter solenoid. Could this be an internal issue with this user panel?
@joediana5055
9 ай бұрын
Hey have a question why type of soldering wire is that. 😊
@omarsworld3227
3 жыл бұрын
Question had my fuse box repaired locally and it’s starts now but my problem is I can’t get the truck to shut off Every thing says on and this wasn’t an issue befor the repair
@carlwilson3723
2 жыл бұрын
Something wasn't done correctly,they should have but a auxillary relay into the system,by doing this you don't have to remove the fuse box,check some of the other sites you will see what I am talking about.
@migueldeleon505
2 жыл бұрын
Have you ever gotten your issues fixed and if so what was it?
@omarsworld3227
2 жыл бұрын
Yes I figured it out. the work done to my fuse box was done correct the problem was that the previous owner or some one before me wired in a wire from the ignition switch to the fuel pump removed the wire and all is good
@JHenry-tt5mp
2 жыл бұрын
Thanks so much. Seriously awesome video. What was that solution you used at 5:10 to clean the board after soldering?
@migueldeleon505
2 жыл бұрын
Most likely a form or resin to help the solder, and/or isopropyl alcohol. But for sure he wiped it down with an alcohol wiper after.
@candiceburke9671
Жыл бұрын
Even IF I were to attempt this, how would I obtain the part?
Пікірлер: 18