good video.. not expecting an answer --- but if you were doing axle shafts at the same time will they pull out through the open hub without the bearing in place or do you still have to pull the top ball joint nut ?
@michaelrodman6646
4 ай бұрын
thanks for a no jive, straightforward video.
@DJDom
2 жыл бұрын
thank you
@travishanson166
Жыл бұрын
I get to tackle this on Thursday in the driveway....probably during a snowstorm.
@j3rs3ysfin3st97
11 ай бұрын
Thanks for the vid, I have to do this tomorrow 👍🏼
@bobklosterman9738
Жыл бұрын
What did you do in the time between the first few whacks and the last few (when the camera angle and the lighting changes) to get that old hub assembly loose? Mine is not budging.
@travishanson166
Жыл бұрын
Probably kept on whacking. An air hammer is handy.
@joea4501
Жыл бұрын
Great, thanks 👍
@staceywoods9041
Жыл бұрын
Sooooo. You took it apart. What about the replacement and reassembly?
@paradiseprod6153
Жыл бұрын
after you remove the surface rust you just put the new one on the same way you took it off
Пікірлер: 10