In addition to previous question the shaft fell out as I took off oil pump can I put the shaft back up through the oil pump without timing issues?
@dirtcheapmedia3390
8 ай бұрын
Late reply but 99% sure the answer is yes. I think I had to do the same thing on mine as well it wouldn’t affect timing unless you removed the cam gear synchronizer.
@anthonyplew9529
10 ай бұрын
Sorry I meant push rod not shaft
@dirtcheapmedia3390
9 ай бұрын
I’ll be honest I have now idea what you’re talking about at this point. Pushrods can’t fall down unless the lifters fall as well. Idk I’m not there to look at it 🤷♂️
@anthonyplew9529
10 ай бұрын
So I took my camshaft off as well as my oil pump in my 04 Ford freestar 4.2. So can I put the shaft back in as it was when I took it out if I didn't do anything else?
@dirtcheapmedia3390
10 ай бұрын
Assuming you didn’t wipe out cam bearings and lifters didn’t drop I don’t see why not
@CatRatchet44
2 ай бұрын
how do you determine which way to point the arrow?
@dirtcheapmedia3390
2 ай бұрын
On the cam gear synchronizer tool?
@CatRatchet44
2 ай бұрын
@dirtcheapmedia3390 yes, do you point it at the circular indention on the time cover? Thank you so much for the videos BTW!
@dirtcheapmedia3390
2 ай бұрын
@@CatRatchet44 as long as engine is at top dead center you can install the cam gear synchronizer pointed in any direction as long as the cap tool is on. The only difference is trying to install the plug install and removal easier.
@CatRatchet44
2 ай бұрын
@dirtcheapmedia3390 much appreciated brother!!
@CatRatchet44
11 күн бұрын
@@dirtcheapmedia3390 how did you set the engine to TDC without the harmonic balance on?
Пікірлер: 15