Many people just clean the sensors to get the light to go out. I would have tried that b4 investing in new sensors. Good video. thanks
@PickyOne
5 жыл бұрын
Keep up the good work, keep making Sienna videos. I don't have a problem with my speed sensor, but I came here after I watched your strut assembly replacement video. Thanks.
@projectfixit
5 жыл бұрын
Cool Thx! I do have some upcoming videos. I have a radiator replacement scheduled as well as timing belt/water pump replacement. Then, I have front and back brakes to replace.
@shashisharma9210
4 жыл бұрын
Thanks. You kept the camera at the right angle. Sometime it is hard to follow in other video but you have done it right
@projectfixit
4 жыл бұрын
I appreciate the feedback! Thank you.
@davidkeohanknudsonms8949
4 жыл бұрын
You did an awesome job explaining and shooting video. Just had a spin-out on freeway with 2004 Sienna and ABS dash light was on but brakes always worked so this might have been the solution...Thanks for the post.
@projectfixit
4 жыл бұрын
Anytime! Thank you for watching.If your symptoms continue, you may need a front end alignment as this was a part a strut replacement job for me. After ward, I aligned the front end and my symptoms have not returned.
@BenjimenAnderson
3 жыл бұрын
Thanks so much for making this video.
@projectfixit
3 жыл бұрын
You are welcome! Thank you for taking the time to comment!
@AtomicPanda125
3 жыл бұрын
Awesome stuff, thank you!
@projectfixit
3 жыл бұрын
You are welcome. Thank you for taking the time to comment. I truly appreciate your feedback.
@mattmurillo331
3 жыл бұрын
nailed it just the right lenght
@miguelzelayatupuedeshacerl4124
4 жыл бұрын
Nice video my friend greetings from el salvador
@projectfixit
4 жыл бұрын
Thank you for watching and for your kind words!
@elvinestrella1098
Жыл бұрын
Can you do a video on how to change the abs pump?
@yassinerah2415
4 жыл бұрын
Thanks for the video Am having the same problem on my 2005 Sienna.my question is there any problem if I didn't change it sooner because am busy don't have time to do it these days thanks???
@projectfixit
4 жыл бұрын
Well, take caution around cures. If your car is doing what mine was which was engaging the ABS system, it can be quite alarming when it happens. All in all, make the repairs as soon as possible and make sure you get your front end aligned. If your car's steering wheel is slightly to the left or right when driving straight, this could amplify the symptoms or be the main cause of your symptoms.
@kenyu270
4 жыл бұрын
Thanks for the video. I am having the same problem on my 2005 .ABS and break light on and off with no Code(use Launch 5001 )And the lights be disappeared after restart the engine every single time. Is it a big problem?
@projectfixit
4 жыл бұрын
I typically get those lights when I have an o2 sensor code. Since you haven't any codes, maybe you just need a front end alignment. Is your steering wheel centered when driving straight? If the issue is bad enough, the ABS system will kick on while driving. This is quite freaky when it happens and that is the time to be sure you get it fixed.
@jaysunfjord7390
3 жыл бұрын
What were the symptoms that lead you to replace the abs speed sensors? I have a 2002 Toyota Sienna that has been to three shops with brake problems. The brakes work, but when at a full stop the pedal slowly sinks to the floor and looses braking power. If I release the brake and then press again the vehicle stops, but the sinking begins again. I have had the master cylinder replaced twice, and replaced the ABS control model with a rebuilt one. I also replaced the abs hydraulic unit with a used one. Today, one day after getting back from shop, the abs light came on, the wheel pressure light came on and the emergency brake light came on and the speedometer stopped working. The next thing I will replace is the wheel speed sensors.
@projectfixit
3 жыл бұрын
Oh my. You have a whole lot going on, here. Where do I start? #1 the reason I replaced the speed sensor was because of a beeping sound under the dash while in a turn and the brakes applying themselves!. It was crazy. However, I made front end linkage and suspension repairs along with the sensors being replaced in the video. I finally had the front end aligned. After all this, my problem was resolved. #2 I am having the same issue with my brake pedal sinking to the floor right now while at t a stop light. My first angle of attack was to replace the brake fluid and bleed the brakes. This helped a ton! However, I can still feel the brake pedal sink slightly while at a stop light. I was thinking about replacing the master cylinder, but reading your comment, I might not. maybe its a vacuum line or brake booster issue?....not sure and too early for me to tell. #3 tire light should be easily addressed by adjusting the tire pressure, but take the car back to the shop immediately! The brake light might be caused by low brake fluid level, and the ABS lights could be tied to a number of items all which should be addressed. I wish all the best for you. Be safe.
@DannyMerida7
2 жыл бұрын
How did you know that that was damaged? Any light on the dashboard?
@projectfixit
2 жыл бұрын
Honestly, I was replacing the sensors along with other work I was doing at this time. (Front struts replace + ABS Sensor replace + Front end alignment) My symptoms were an annoying beeping sound behind the dashboard and in some cases the ABS brakes would engage when maneuvering a curve at approximately 20 mph. Since my font struts were clunking when going over bumps and steer wheel was not straight when driving straight, I figured one of the three repairs would fix my problem fully. Although steering alignment was most likely the cause. I had piece of mind replacing the sensors.
@davidestrada9701
2 жыл бұрын
I have a 2005 Sienna, it stops running when I move the shifter from any position. If it's running and I move to reverse it will stop running. If I restart it in go into reverse it will go into reverse but once I move the shifter to the drive position it will stop running. I went to AutoZone and after using the scanner, their system advised me to replace the ABS sensor as code C0200 (which is a code that recently came up), on top of other codes (P0171) that had been an ongoing part of the check engine light on my dashboard. Do you think it's possible the ABS sensor is causing the scar to stop running when the shifter is moved to another position?
@projectfixit
2 жыл бұрын
If you are having shifter issues with the car not shifting to travel in the direct you desire, check out this video I posted. This would not pertain the actual engine codes, though. kzitem.info/news/bejne/lK18sGGEqpqcbG0
@joelloya87
3 жыл бұрын
Did your brake lose pressure? I have to floor the vans brake pedal in order to stop
@projectfixit
3 жыл бұрын
No. We have full pressure. It sounds like you might have air in your brake system. You should have the system bled soon! I would not drive the vehicle in this condition.
@davidcobarruvias4185
3 жыл бұрын
@@projectfixit hey my dad changed the abs module as well does it need to be reprogrammed? Another question when breaking the pedal sounds like its hitting a metal any suggestions?
@projectfixit
3 жыл бұрын
@@davidcobarruvias4185 I am not certain about the ABS module and programming details, but the metal to metal sound when braking sounds like brake pads are worn.
@lovetohuntlovetohunt6241
4 жыл бұрын
Ty, I'm having an issue with my 07 sienna but no codes to know which wheel has the issue, & the abs light has not came on, but sure feels terrible to slow down & complete the stop, but no problem on a sudden stop, i may try cleaning them first, & go from there, i was told it could be in the steering, may need to replace steering sensor/module
@projectfixit
4 жыл бұрын
In my case, I had replaced a number of steering linkages which probably contributed to my issue. This particular video focused on the ABS sensors. If your alignment is good, I suppose it could be the steering wheel sensor. ChrisFix has an awesome video on replacing that component.
@thetiredadtv6421
5 жыл бұрын
How have the sensors been working out now? I am having the same problem with my sienna ?
@projectfixit
5 жыл бұрын
No issues since. For me, it most likely was a combination of low tire pressure, sensors, and possibly my front struts. I addressed all 3 at the same time.
@projectfixit
5 жыл бұрын
Check your steering wheel alignment. If it is not pointing straight when driving straight, this could be an issue affecting your steering wheel sensor from accurately reporting steer angle. If this is the case for you, you may want to start with a front end alignment....just a thought
@thetiredadtv6421
5 жыл бұрын
@@projectfixit thank you my steering wheel is a little off to the left ill get that checked out first
@2009duny
5 жыл бұрын
My 2002 Sienna, 72,000 miles. ABS light flashing when car is not rolling, driving (rolling), light goes off. I cleaned the 2 front sensors, same old problem. Need your advice. Thank you.
@projectfixit
5 жыл бұрын
This car is a bit older than mine, but when the ignition switch is turned ON, the ABS warning light and BRAKE warning light go on for about 3 seconds as part of a self test. If the lights flash or stay on for a longer period of time, but extinguish when you start driving, you may want to check with a scan tool to be sure no error codes exist......or check your brake fluid level. If brake fluid level is low, it might be time to change the brake pads.
Пікірлер: 38