I am not responsible for injuries or damages, I made this video as an educational guide and better idea for how to do this job.
How to replace the starter on a 2005-2010 WK Jeep Grand Cherokee 5.7L Hemi without removing the cross brace and driveshaft. “Easy” replacement
Park in a flat surface, let vehicle cool, safely and secure lift the front end and place jack stands under, or use ramps, make sure to chock rear wheels. Disconnect negative battery cable, remove driver front wheel, remove plastic wheel well cover. 13mm bolt off the starter, undo the clip/wire on the solenoid, underneath the vehicle now, locate and remove two starter bolts(should be 15mm possibly 14mm, don’t strip these out!), remove the starter up and out the wheel well, for better clearance loosen the steering column brace, you’ll have to wiggle the starter out, it’s not difficult but can be annoying be patient it’s really bad, as you’re installing the new starter install the top bolt before the bottom to prevent cross threading and making your job easier. Reverse everything else. If all else fails and vehicle still doesn’t start or clicks only, check the starter relay under the hood, also verify your neutral safety switch, ignition switch and battery are all good.
Негізгі бет Музыка 2005-2010 WK Jeep Grand Cherokee 5.7L Hemi Starter Replacement
Пікірлер: 9