Best video for this repair!!! No useless chatter from the person doing the work. Clear and straight to the point!
@steveloux4709
2 ай бұрын
Yours is one of only two (2) videos I have found that address a broken blend door shaft which requires replacement of the "Auxiliary Air Conditioning Evaporator and Blower Upper Case," GM part number 8889157; it is still readily available as an OEM part from many sources, including of course, GM.
@natedagreat1571
2 ай бұрын
would you by any chance happen to know how to get that screw out at 3:31?
@steveloux4709
2 ай бұрын
@@natedagreat1571I’m going to find out this week. :). Another video suggested a 7mm universal joint.
@natedagreat1571
2 ай бұрын
@@steveloux4709 I'm on my 3rd day trying to get that out. i'l try the 7 mm
@steveloux4709
2 ай бұрын
@@natedagreat1571 ideally a 7mm open end wrench. I used a miniature crescent wrench because that’s all I had and with a good deal of patience got it in. One tip would be to run the screw into the hole before installing the duct in order to create some threads. Then remove the screw, and install the duct. Then the screw will start easier.
@steveloux4709
2 ай бұрын
Before installing the new duct, load the three back clips into position on the bottom half and use some good quality duct tape strips to keep them in position. It’s much easier then to reach in with your finger and roll the clip up onto the top half without having to fumble blindly to position them.
@fandango2663
Ай бұрын
Mine did the same thing, but I used JB weld, and it's still holding!
@swthero
3 жыл бұрын
Great video!! thank you on the tutorial now I can fix my back ac. Was having issue with the AC not working on top vents
@christophercrowe6648
2 жыл бұрын
Thanks for explaining everything
@2Jeezuzisreal
7 ай бұрын
05 Yukon. I'm just going to remove the actuator and drive a screw in there to hold the flapper door open so it will always be warm air for my winters. Since my AC doesn't work anyways and it's a pain in the as to repair.
@killanige
4 жыл бұрын
I have to look into line God I hope its just the actuator. Thanks for the vid
@BABALAGAJIGAPOO
4 жыл бұрын
Dude great job and thank you!!!!
@sinaloa818
2 жыл бұрын
Any ideas as to why only one of the rear AC vents blows air out? I have no air coming out of three rear ac vents, just one. I'd appreciate any thoughts.
@garrinbenston8303
3 жыл бұрын
Thanks good details
@colt5189
2 жыл бұрын
I wish you showed putting in the new case. Did you have to disconnect the A/C? Did you replace the whole box, or just the top half?
@seantire
3 жыл бұрын
Thank you 🙏🏻 for the video bro 😎
@user-bp5jk4fs6v
3 жыл бұрын
My pleasure! Glad it was helpful!
@thomasrice7416
3 жыл бұрын
Did you have to disconnect ac lines
@disabledvet5124
3 жыл бұрын
Does freon run to this back part ? I keep losing freon and cant find the leak. It's a super tiny one cause a full charge last about 2 months.
@mlez7197
2 жыл бұрын
great video ? hou much is the housing? thank you in advance
@JesusGarcia-rc1vy
Жыл бұрын
Were can I find the blend doors at ? Do i have to find it at the junk yard ?
@steveloux4709
2 ай бұрын
Still available as OEM. Would not recommend getting one from the junk yard - it's probably only in marginally better condition than the one you have and ready to fail due to age.
@yovannipille6978
3 жыл бұрын
Do you have a link for the housing
@victorvaldez9655
2 жыл бұрын
Where did you order the housing
@troubledsoul764
3 жыл бұрын
Did you have to disconnect the ac lines?
@steveloux4709
2 ай бұрын
no - and the lines you saw him move were actually associated with the heater core by the way.
@LS-ux2kt
2 ай бұрын
It’s funny how you don’t show how you took it out after taking off the bolt and clip on the bottom 🤦🏽♂️
@LS-ux2kt
2 ай бұрын
pretty much have to replace the whole entire thing now thanx a lot
@jarrheadja1522
3 жыл бұрын
Why ebay just go to a junkyard and get a replacement thats what i did much cheaper than the route you went
@thomasrice7416
3 жыл бұрын
Did you have to disconnect the ac lines
@himeedajew
3 жыл бұрын
Sorry to say very misleading video. Why do you need to change the case if just a blend door is broken? Look at the new case. Blend door is not even in it. It's a separate piece. Video is great to show you how to take it apart. Replacing whole case that DOESN'T INCLUDE THE ACTUAL BROKEN BLEND DOOR is wasteful. Just buy the blend door for $10
@colt5189
2 жыл бұрын
Do you have a part number for the blend door? All I see mentioned is people saying you have to buy the whole case. Thanks.
@chasebushnell5184
2 жыл бұрын
I just went to the junkyard and took them out of another yukon and plan to replace them tomorrow
@himeedajew
2 жыл бұрын
Ok I take back my comment. You are correct! You need to buy entire EVAP case in order to get that part unless you have a junkyard take the blend doors out for you. I didn't even put back that bottom screw. Pia! And the back clips are a pain also. Thanks for the vid was very helpful.
Пікірлер: 35