Great video guys. Just finish changing my wheel bearing on my 2006 Hyundai Tiburon👍🏻
@vinnyc.1265
6 ай бұрын
I wish the fronts were this easy.
@Crazzilla
5 ай бұрын
Nevermind the whole 170ft lbs of torque, slapper on there lol. I wonder how that holds up over time. For those screws, definitely always use an impact drill with a #3 phillips head on it. They tend to come straight out, even if stripped a bit.
@chillydawgg4354
9 ай бұрын
I don't think you need to replace the screws in the rotor, also couldn't you just loosen the caliper mount bracket & swing the whole caliper up out of the way?
@rodpanhard
2 ай бұрын
You can just drill them out, once you get the head off the bolt the disc will come off and the threaded stump that's left usually comes out easily enough with a pair of locking pliers, if not the wheel bolts / nuts hold the disc in so it's not a disaster of you don't repace it.
@jeffreymitchell4904
Жыл бұрын
Great video.
@undisputed1one
2 жыл бұрын
Thanks so much
@troydoggett4561
11 ай бұрын
next time set the camera up on a tripod.. the camera guy forgot he was recording half the time
@jwoo820
Жыл бұрын
how did u put the abs sensor on
@svn9233
Жыл бұрын
I’m about to do the same change and if I remember correctly, the abs is passive and not active, so the sensor just sits above the cranked ring
Пікірлер: 12