Been having same problem on my prarie. One spark on rear cylinder. You definitely put out the most thorough and informative video to suite my situation. Much appreciated
@chuckbobuck1302
2 жыл бұрын
I had a similar problem with spark on front cylinder but none in the rear. Took all the plastic off and went through most of these steps. In the end it turned out to be dirty connectors on the ignition coil for the rear cylinder. I had previously spent hours dicking around trying to get it running. Thanks for the video, I was minutes away from rolling it into the yard and setting it on fire.
@farmboyfixes
2 жыл бұрын
Thats some good troubleshooting you did.
@fabiosofrafuriousfish2037
Ай бұрын
Hi nice to meet you Fabio, I think I have the same problem because the Quad shoots at me. Your quad also has carburetors right? Can I know where to buy the control unit at an affordable price. Do you have a link?tanks
@DEWWYA88
Ай бұрын
Where can I get the literature that you are using in this video. I'd like to purchase an exact copy. Thank you
@SpoMotoCitySports
Жыл бұрын
good work and thank you for sharing you experience
@Mani_Grewal
Жыл бұрын
Hi, appreciate your video. We have the exact problem, we are getting one spark and nothing after that. Our parameters: Coils: 0.1 ohms Vehicle down: 0.07 ohms Crank sensor: 435 ohms Peak did not even go to 1 volt AC Any feedback is appreciated Thanks
@DeltaPrimePropertiesLLC
4 ай бұрын
I got no anything. no tone, no screen nothing. 2005 bruteforce 750. I like your video
@mikemccauley9757
7 ай бұрын
Hey there! Hope youre still around and can comment a suggestion. My 07 has 0.000 resistance with my multimeter on the coil connectors. Has one spark on rear and weak sparks on front cyl.. thoughts? Edit: new to me bike, has dyna cdi installed.
@DEWWYA88
Ай бұрын
I just checked my spark plug coils with my Fluke 116 set on OHMs "auto". My primaryreadings are 0.2. Secondary readings with spark plug end removed are 4.47 ohms which are within specs. With the primary being out of range @ 0.2 ohms is it safe to assume they're no good and need to be replaced?
@jeffmueller9059
25 күн бұрын
service book says to set scale to 1k it should make a difference for the primary reading
@luisdanielcanas6858
3 жыл бұрын
nice video men. I am having a similar problem. Sometimes the electric ignition and headlights don't work on my brute. Dash light works and brake light too. Today i tap the igniter and it firep up immediately. The solutions to this problem was to reset the belt light.
@farmboyfixes
3 жыл бұрын
You lucky it can still work. Its a expensive part. BTW, I did try hitting it. Thats my first go to thing to do.
@luisdanielcanas6858
3 жыл бұрын
@@farmboyfixes same problem today. Ran good all day and sometimes don’t start. Can you give some link to buy one for a Brute force 650(normal not i model)2010. I am in USA
@farmboyfixes
3 жыл бұрын
@@luisdanielcanas6858 Im up here in Canada, but I got my igniter box off Ebay. But, you should be able to phone any atv store and get yourself a Dynatech box.
@luisdanielcanas6858
3 жыл бұрын
@@farmboyfixes thanks men. I “ll look one on ebay
@rifrifeno4178
4 ай бұрын
Hola companiero tengo un fallo de pompa de gasolina i no tiene chispa ala bojia i gracias
@27mjbruce
3 жыл бұрын
great video thank you
@farmboyfixes
3 жыл бұрын
Glad you enjoyed it
@craigwashington446
Жыл бұрын
Got a question
@luisdanielcanas6858
3 жыл бұрын
Hey men i have a question. I checked all that you listed on the video everything is fine. The atv start but only run on back cilynder. I am really thinking my CDI is passing out..
@farmboyfixes
3 жыл бұрын
it ran on one cylinder?. hmmmm, my ignitior would not even do that. maybe move the plug, then wire,then coil. that will show you if the problem goes to the front cylinder
@luisdanielcanas6858
3 жыл бұрын
@@farmboyfixes hahaha one terminal in the left coil was disconnected. Problem solved ;)
@farmboyfixes
3 жыл бұрын
Good find. Happy trails
@luisenriquemagaña
10 ай бұрын
@@farmboyfixeshola no has tenido problemas con el carburador? No tose? O escupe por el escape?
@27mjbruce
3 жыл бұрын
Im working on the same unit I had to change the flywheel is it possible if the keyway falls out I would loose spark
@farmboyfixes
3 жыл бұрын
Hmm, I don't think so. The crankcase sensor should sent the signal for correct spark timing.
@27mjbruce
3 жыл бұрын
@@farmboyfixes thank you and I found the part number DFS2-15
@27mjbruce
2 жыл бұрын
I received the new igniter still no spark any suggestions
@farmboyfixes
2 жыл бұрын
New igniter didn't work, thats shitty. You will have to go through your wiring harness and make sure there is no breaks in the wires.. Can you confirm you get voltage at the coils? These Brutes can sometimes be a devil to fix.
@jsimm4587
2 жыл бұрын
@@farmboyfixes how much power should be to the coils ?
@adrew1963
Жыл бұрын
.09-.1 and your getting .7 that is not in the range of .09 to .1 its 7x higher if that matters which maybe it doesn't
@jacek1235
2 жыл бұрын
Hello, I have a problem with my brute force 750 fi, it spins to half the speed, at full throttle it chokes as if it was cut off by something
@farmboyfixes
2 жыл бұрын
I would look at the dual carbs, if you have confirmed all else.
@marekvranka4832
Жыл бұрын
Hello, I have exactly the same problem as you. Did you fix this problem? Thanks for any help
@jacek1235
Жыл бұрын
@@marekvranka4832 Hello🙂 Yes replace the fuel pump.
@27mjbruce
3 жыл бұрын
what is the story with the buzz connectors
@farmboyfixes
3 жыл бұрын
Buzz connnectors ???
@WTF.416
2 жыл бұрын
If you are referring to the buss connecters in the wiring harness holder brutes need to be taken apart and soldered together there are KZitem videos for this if you have not done it should be a square connecter wrapped up tape from factory in the harness. It can give you all sorts of electrical gremlins
@rubenmatos100
2 жыл бұрын
How do you replace the shaft sensor?
@27mjbruce
3 жыл бұрын
what is the part number for the dyna
@farmboyfixes
3 жыл бұрын
I got it off ebay. I can't find the part number, but I just type my year and engine size. 2007 brute force, 750 CDI.
@bobhetherington811
2 жыл бұрын
OL is open load not overload. Great video though
@bozostadic6680
2 жыл бұрын
Can u make like a google slide with the diagram plz and send me the link?
Пікірлер: 47