Thanks!!! Could not find any info on this!!! Well done sir!!!
@mitchdodd9732
Жыл бұрын
Orange wire is not necessary unless u want reverse buzzer
@912ruckus2
2 жыл бұрын
Do you know if the orange wire to controller is positive or negative and what voltage?
@sandymajors6015
2 жыл бұрын
Does the controller M- go to A-1 0n the motor and the forward and reverse post go to the M- on the controller also
@simeonc.4909
8 ай бұрын
How many volts should the small red wire be?
@thghho
5 жыл бұрын
Hi, I have bought used Curtis 1236. without changing any parameter, can you use any THROTTLE TYPE on this controller or do I need to identify the pre-programmed THROTTLE TYPE set by previous owner? Is there any anyway to detect current throttle type?
@whack-o-dillies1908
3 жыл бұрын
You can use any throttle type.
@whack-o-dillies1908
3 жыл бұрын
Sorry, I'm not sure. Try the source listed at the end of the video!
@ElectricTractor
3 жыл бұрын
any advice on programming a new un-programmed Curtis 1226 controller e,g, assigning Analogue inputs and aligning I/O switches thank you
@whack-o-dillies1908
3 жыл бұрын
Sorry I don't have anything on that. Try the source in the video at the end!
@ElectricTractor
3 жыл бұрын
Thanks for all your advice I finally figured it out I was omitting to press the save button after high had done the re-programming!
@williamhartman9
Жыл бұрын
What type of speed increase did you get?
@whack-o-dillies1908
7 ай бұрын
I didn't really check the speed. However the power is substantial as compared to stock.
@carl-krauss
Жыл бұрын
Could you share this document by any chance?
@whack-o-dillies1908
7 ай бұрын
Sorry, I made the document on a PPT and need to try and find it.
Пікірлер: 15