That is a gorgeous looking truck really like the content not to much in 6.4s out there since diesel tech Ron passed away really like the content man keep it up
@rafaelcarrillo943
3 жыл бұрын
Great!!! Thanks for the Vid, going to try!
@pilotd
2 ай бұрын
I laughed too hard at your reference 😂
@joshtupman8774
2 жыл бұрын
I watch your videos religiously and don't understand how I haven't seen this one until now. I've had just about my whole front end rebuilt....ordered the MC shaft today and hoping it takes care of the slop I've had for a while.
@USAF99
2 жыл бұрын
I appreciate the hell out of the support if the slop is really bad you might also look into adjusting your steering gear box not a whole lot though it don't take much
@joshtupman8774
2 жыл бұрын
@@USAF99 thanks, will do!
@joshtupman8774
2 жыл бұрын
replaced it this evening. pretty simple job. seems to have alleviated alot of the slop i had. i especially noticed it when going over rough roads/terrain, not nearly as much of the steering wheel bouncing hard left to right. might still need to adjust the gear box a little. thanks for the help brutha!
@kieranbarrett5900
Жыл бұрын
Good video 👍👍
@TonightWeGrill
2 жыл бұрын
Idk about 08 and up but 05-07 it’s way easier to take the air box out and get to it that way. At least it is for me in my 05. Second video I watched and I subscribed!
@USAF99
2 жыл бұрын
Yeah, 08 and up the degas bottle sits right over the top of all of it and the air box is on the passenger side. Sure would have been easier if it was reversed like yours for sure!
@travissk5036
3 жыл бұрын
Thankyou
@user-oz2io7cy7n
Жыл бұрын
thanks, do you have more videos for F250 2008 model , 6.4L 4X4
@AjGalloway95
Жыл бұрын
You quoted Westen it made me like you more
@arturojimenez4382
2 жыл бұрын
my built date says 07/07... would it fall under the before 07/30/07 build or after 07/30/07?
@USAF99
2 жыл бұрын
Before. 08/07 would start the change.
@joesocha1694
3 жыл бұрын
Did it help the steering? Thanks for the additional info on 2008 models as I am sure I would have bought the wrong one...lol
@USAF99
3 жыл бұрын
Absolutely! Mine was the original one on from Ford- 12 years old! Its amazing the rubber stood up that long slingin those big tires down the trail!
@joesocha1694
3 жыл бұрын
@@USAF99 Thanks. Will try this.
@drostly3220
2 жыл бұрын
@@USAF99 was there noticeable slop in the one you took out? Was hoping your kind of point out the slop on the old one..
@jasongovols1060
3 жыл бұрын
I have the exact same issue with my 09. Over the past yr I've replaced everything. A few weeks ago I changed the caster shims to 2° Carli shims. This past week I did both upper and lower ball joints..... Which was not easy. But it's made a huge difference but my steering wheel is doing the same thing as yours. Why not replace the entire shaft. Is the lower all that's needed in your case. Thanks
@USAF99
3 жыл бұрын
The upper on these are essentially a solid steel rod. The lowe has a cushion joint that can go out. It did make a huge difference but I ended up buying a Ford replacement and swapping the doorman part out. It drove me nuts knowing I had a dorman part between my steering wheel and the gearbox.
@juansebastianlopez8828
3 жыл бұрын
@@USAF99 So do you think is better to stick with a Ford part?
@USAF99
3 жыл бұрын
@@juansebastianlopez8828 in most remove and replace instances where performance gains are not what you're after, yes. There are a few instances where the OEM part was trash, in those I say do your research and make an informed decision before you just go down to the local AutoZone.
@juansebastianlopez8828
3 жыл бұрын
@@USAF99 Thank you. Do you think in this case the OEM drive shaft is better than the Dorman you first used?
@USAF99
3 жыл бұрын
@@juansebastianlopez8828 In this case, absolutely.
@travisboulton8610
3 жыл бұрын
Use a dorman shaft on my ford, should have used ford parts which is what I had to do the second time around.
@USAF99
3 жыл бұрын
I used it for a couple weeks while waiting on the Motorcraft part to come in. Good call on MC parts!
@juansebastianlopez8828
3 жыл бұрын
@@USAF99 Hey bro what's the MC part number? Same as dorman?
@joshtupman8774
2 жыл бұрын
@@juansebastianlopez8828 9C3Z-3B676-A
@mickeybinas
6 ай бұрын
Highway speeds on the dirt road
@da5172
17 күн бұрын
Ford never could build a front end in these trucks
Пікірлер: 33