Couldn't even get to the point where I had to bend the tab in the wheel well until I did 2 more things past what you did. 1) removed the spacer for the lower idler held on by 2 10mm bolts and idler bolt. 2) used an impact gun to remove the pulley through the wheel well. After that it came out easy - no bending anything. Remove pulley on replacement part, put it in and re-install pulley through wheel well. Hope that helps someone. Appreciate that you did this video - there's little info about this PITA year 3.5 Altima.
@joshuabarr6511
4 ай бұрын
I'm about to do this job. Was gonna remove the idler pulley, disconnect the ac and drop that down a bit and then drop one side of the subframe...need to replace a control arm anyways
@Homemedrunkimtake
5 жыл бұрын
Makes a video on how to remove alternator... Already removed alternator 🤦🏽♂️
@sctantrums
7 ай бұрын
why take the fan out if you are removing thru the wheel well?
@kehresc
3 жыл бұрын
I'm stuck on the part removing the AC compressor. I have it loose, but can't lower it enough out of the way. Did you disconnect the wires from it?
@ttam7777
4 жыл бұрын
"I'm cheap..." as he raises his lift. Lol. Did you make the first part of the video where you physically removed the alternator?
@satoboi3065
4 жыл бұрын
What caused the coolant leak. I'm confused
@taraevans1909
4 жыл бұрын
Man I need some help
@kylegraves6923
4 жыл бұрын
This video is not helpful at all. Look like the first 95% of this video is missing.
@justinwest7679
4 жыл бұрын
Dudes clueless, no need to pull fan or drain coolant. Unbolt ac comp, let hang, loosen two front subframe bolts, unclip power steering line, snakes 🐍 out bottom
@brandongarcia3119
3 жыл бұрын
How did you get the the ac comp bolt top
@pwooster
Жыл бұрын
The top front bolt for the ac compressor looks like a pain to get to, are you able to remove it without removing anything else around it?
@joshuabarr6511
4 ай бұрын
About to do this job tomorrow I'll let ya know how it goes
Пікірлер: 15