First, I'd like to say that I'm in the military and purchased this 2008 Sequoia while deployed. It was used as a work vehicle for a church so it has relatively low miles for its age (180k). I think it got used a lot to transport chairs/equipment and maybe periodically used to transport people for church functions. I immediately wanted to do the full car audio upgrade as the stock speakers were dry-rotted. I figured I would share my build with the community with all the things I wish I could have found in a place like this. I'm Air Force avionics so I figured I would also share some of the wire repair techniques I use on aircraft here because I see some atrocious videos. What you see here may not look super pretty, but it will work way better than crimping your connections and prevent feedback buzz from plaguing and likely destroying your audio system. I feel like the installation is super clean and the whole thing looks and feels stock when complete. Feel free to ask me questions here, or on the youtube video. Mind you I didn't feel like using much of the stock anything when it comes to the audio (steering wheel controls included) but for those of you who would like to you could buy both of these things and get your volume knob/voice controls.
Wiring diagrams available at tundras.com:
www.tundras.co...
www.crutchfiel...
www.crutchfiel...
I personally hate it when I hit the steering wheel buttons by mistake and have it call someone or begin dictation. I'd rather use the hands free on my phone and couldn't justify paying almost 300 dollars for a bunch of hardware that is just adding complications to a system that will never go back stock.
Pro tip for the backup camera install. Make sure you run the wires around the track for the rear window and leave enough play in the wires for the large wiring harness to travel with the trolley up and down. You cannot just wire tie all of the wires in there together as some are connected to the rear window and will pull your connections apart.
Here is the shopping list in all her glory.
Shopping List
* MZUHI FLUSH MOUNT AUX/USB ADAPTER B0C4BF1ZTB (VIDEO SHOWS ANOTHER)
* SCOSHE TA2073B DASH MOUNT KIT
* 4X ALPINE SPE-6000 6.5 SPEAKERS @ 4 OHM
* PIONEER DMH-1770NEX
* ALPINE TYPE R 1 OHM 12" SUB
* ROCKFORD FOSGATE 1200 PRIME @ 1 OHM SUB AMP
* ADDICTIVE AUDIO 250 BOOST SERIES @ 4 OHM COMP AMP (this must be bought from an audio shop, good amp)
* 0/1 GAUGE POWER/GROUND CABLE (SUB AMP)
* 12 GAUGE SUB SPEAKER WIRE (SUB SPEAKER)
* 8 GAUGE POWER/GROUND CABLE (COMPONENT AMP)
* VOXX ACAM4 HD BACK UP CAMERA
* 2x MJM FRONT SPEAKER ADAPTER SAK0105525
* 2x DKMUS REAR SPEAKER ADAPTER DKM003LABA (I FABBED MY OWN)
* HILLMAN STEEL ANGLE/PERFORATED STEEL & SELF TAPPING METAL SCREWS
*OPTIONAL*
*Uolor 925Pcs Car Bumper Retainer Clips Plastic Rivets Fasteners (best 20 bucks you will spend if you work on your yota alot)
*haisstronica 120PCS Solder Seal Wire Connectors-Marine Grade
*METRA 70-8113 WIRING HARNESS (FOR HEAD UNIT POWER)
*WIREFY HEAT SHRINK TUBING KIT
*GLARKS 155PCS WIRE FERRULES & GLARKS 2PCS WIRE TERMINAL CRIMPER (4 CLEAN INSTALL)
Негізгі бет Тәжірибелік нұсқаулар және стиль 2008 Sequoia 2nd Gen Toyota/Sequoia (2007-2013) JBL Experience car audio backup camera full install
Пікірлер: 2