You just helped me pull one in minutes instead of hunting it down. I wish there were more than one thumbs up to give!!!
@timothyholcomb823
Жыл бұрын
Thank you!!!!! Done destroyed my speed sensor cause I didn't know..god bless!
@ArmenArmenjs
4 ай бұрын
I tried the connector is very hard to un plug with my left hand. there is no room in there for both hands.
@Hullified
Жыл бұрын
Noice. Thanks brother!
@paulieloks6216
3 ай бұрын
I rewired the connector to my ignition coil wrong because i broke the old one then when i ran the car one of my ignition coils burned and now my car doesn't start at all can it be that sensor?
@MCTennn
9 ай бұрын
I want to see it. 😮 thanks 😊
@SgtBouncer-vw5cp
Жыл бұрын
What kind of oil do you use to lubricate the O-ring
@jasonreyes8511
Жыл бұрын
I had some old engine oil lying around my garage dipped my finger and lubricated the o ring
@ryangarcia3806
2 ай бұрын
2007 to 2009 right?
@jimmyarias9102
Жыл бұрын
Y did you change it ?? Did not start up .. did it just crank ??
@jasonreyes8511
Жыл бұрын
Yes my car would crank but it wouldn’t start and the code that came up in the check engine light was the crankshaft sensor P0335
@StudioFive26
4 ай бұрын
Thats a speed sensor
@TechnomancybyD
2 ай бұрын
That is not a speed sensor, its the crankshaft position sensor as stated. On this model the primary speed sensor is right under the ECM and the secondary speed sensor is on top of the transmission about dead center back of the engine bay, both are accessed from the top side.
Пікірлер: 13