Nice work of arts. Would like to see the process of cutting the frame.
@miguelangelmoripinedo6890
3 жыл бұрын
Está muy bonita la moto. Cómo lo modificaste. Tienes videos paso a paso de la modificación. Si tienes comparta
@kevinefraingomezguzman8404
2 жыл бұрын
alucinante
@aurlbenx7707
4 жыл бұрын
Hi! I really loved your exhaust sound so I bought the same for my marauder (98’, 4000miles ;-) I installed it and the sound is greaaat, in idle it’s working fine, but only in idle... As soon as I grab the throttle, the engine shuts down, turning it quickly or really slowly, it do not go in revs). May I say that I also removed the air box to fit a k&n tapered filter. May I ask you some advice, did you just performed a setting, or replaced the fuel sprinkler? Thank you very much for your help. Best regards
@johnthornicroft3484
4 жыл бұрын
Sounds like you need to reject the carb and adjust the air fuel mixture screw.
@aurlbenx7707
4 жыл бұрын
Thanks John, yes the air intake excessive amount was confirmed by putting a socket on the air filter. With it everything’s fine. Reducing air intake or increasing the fuel flow, what is finally prefered? May I consider that with the new exhaust (bigger), a biggest air/fuel mixture is required ? Thank you!
@Marcus364
3 жыл бұрын
I noticed you have adjustable levers im currently looking for some for my 2001 suzuki gz125 bobber which has been a nightmare. Could I ask what levers you have and where did you get them? Thanks
@sergiu1553
3 жыл бұрын
I eant to make my gz 125 chooper like this
@i_am_Fly
4 жыл бұрын
tryna figure out how you mounted the rear fender after chopping the end of the frame. did you weld brackets to the swing arm or lower frame? asking for a build im doing with a gz250
@SomeGuyOnline27.
5 жыл бұрын
Where did you get this exhaust from?
@johnthornicroft3484
5 жыл бұрын
200mph motorcycles portland
@johnthornicroft3484
4 жыл бұрын
It's a stock gz front pipe with a universal swept tulip exhaust from Ebay.
@leerobinson6684
4 жыл бұрын
Hi how have you fitted that seat and where's it from?? I'm currently building a 125 Suzuki gz marauder bobber however stuck for how to mount the seat like this to the frame any help would be much appreciated. Cheers
@johnthornicroft3484
4 жыл бұрын
I made the seat and had to weld mounts to the frame before powered coating.
@leerobinson6684
4 жыл бұрын
@@johnthornicroft3484 amazing thank you....any tips on making the seat??
@leerobinson6684
4 жыл бұрын
Any social network platforms I can send a pic on??
@johnthornicroft3484
4 жыл бұрын
@@leerobinson6684 make out of cardboard 1st cut to sharp you like. Then pencil on to some 3mm alloy or mild steel. Cut out and use the frame contore, to bend to shape. Then take it to the trimmers to cover like I did coz I cant sew.
@leerobinson6684
4 жыл бұрын
@@johnthornicroft3484 that's amazing thank you...out of interest would you make one the same as this one but all black stitching and if so how much??
Пікірлер: 23