the rotor installation actually depends on the vanes inside the rotor, the design is intended to pull air towards the wheel hub. It is not based on the cuts in the face of the rotor. (these are installed right im just making it clearer just in case someone misunderstands the video)
@KenB350z1
11 жыл бұрын
8:04 shows the vanes going in the wrong direction. One must check the direction of the internal cooling vanes in order to determine the proper orientation.
@PakiJuggernaut
12 жыл бұрын
the Vossen cv3's look sick
@Bpearl2010
12 жыл бұрын
Thanks guys.. The brakes are just BEAST!!
@geeayevette
12 жыл бұрын
I would use hardened shim washers that would fit into the holes that the hex-nut goes in. I would do that, so that the hex-nuts will bear against the hardened washers during tightening, rather than directly against the aluminum caliper. (Maybe a touch of lithium grease on the washers, also). Best. Joe
@oooooo3231
11 жыл бұрын
wow. you need to post more pics! when honda produced the accord version you have i really didnt like it. but the way you did yours i have to rethink about this body style. your stance, wheel selection, color of car, and now your new brake setup really looks great!
@BFMR1062
12 жыл бұрын
its all so a relly good thing to cleen the hub face up whith some emray paper or sand paper or wire brush then cote it whith anty seize compund ather wise 1 you may get brack shuder as the rotor is not lined up and true whith the hub due to rust and dirt bild up betwen the rotor and hub and 2 the anty seize stops the hub and rotor seizing together and making to hard to remove at a later date. Good video for eny one who has never done it tho :)
@jobe613
9 жыл бұрын
very helpful!i may be buying a big brake kit for my genesis coupe
@Kyodaikuma
10 жыл бұрын
wow your accord looks great
@HarZoiD
12 жыл бұрын
So this is your car!! Saw it in the Vossen vid!
@mohammedalrawi9770
8 жыл бұрын
I know its been half a decade since you installed Ksport bbk and might not even have that car anymore. But I wanted to know your experience with the brakes, did you have any issues with them? Thinking to get a set for my daily drive car. Thank yoy!
@ExigeGT3
11 жыл бұрын
Good video, nice car but K sport book shows disk grooves in the other direction.
@ldadol
12 жыл бұрын
never loosen with a torque wrench. it offsets the shims and you have to recalibrate it.
@mytek998
12 жыл бұрын
Very nice video
@phatfool33
12 жыл бұрын
nice job man.
@Bpearl2010
13 жыл бұрын
@supraraycer Thanks man. :D
@Coda5610
10 жыл бұрын
lol bro u put the rotors on backwards
@battosaijenkins946
8 жыл бұрын
@Bpearl2010, hello just asking, is the 8 pot pistons really necessary for street use? It just looks way too overkill and you can do fine with 4 pot setups.
@cgtigrad
11 жыл бұрын
You're beast bro.
@arthurdelatorre
12 жыл бұрын
Bad.ass.car. I have it as my sreen saver on my phone.
@oooooo3231
10 жыл бұрын
oh your the guy with the vossen wheels on their web site. too bad you didn't have this brake setup before you did the video shoot. also im a dealer, I can get you parts like the big brake kit from ksport. anyone else who wants this let me know.
@nicktyronewilliams4978
9 жыл бұрын
Those disc are 100% the wrong way round yes it depends on the way the vains curve inside. They take air from inside and direct air out not in like these are shown how would air get in past caliper to cool . Simple really but fitted so wrong. Very helpful video but do hope no one else had done this method
@liemnguyen4287
10 жыл бұрын
will 19"rims be fit this big brake kit ? Thanks
@KenB350z1
11 жыл бұрын
Yeah, I just bought some Ksport brake and the vanes are going the other way. I think he install them the wrong way.
@cetromero15
12 жыл бұрын
You could have just used a impact driver to remove the screw in the rotor
@R0ckstrmik3
11 жыл бұрын
Car look nice ...he has vossen
@XzTy0o92o0zX
11 жыл бұрын
Shouldn't use a torque wrench to break a bolt that's what a breaker bar is for
@hung817
11 жыл бұрын
How much was the kit?
@175myles
12 жыл бұрын
I see so many cars all done up with nice paint and big wheels, then you see the stock brakes and it just ruins the look, big brakes give you the look of "What's that thing got to need those brakes?".
@Bpearl2010
12 жыл бұрын
175myles Iagree man.. Which is why i am rocking them. Other guy post Of course u have to bleed them...
@dominica7674
10 жыл бұрын
Y just the front?
@AncelMathew
8 жыл бұрын
how much did this cost you?
@R0ckstrmik3
11 жыл бұрын
Imagine 16 in
@supraraycer
13 жыл бұрын
@Bpearl2010 beautiful car man, i saw it on canibeat.com (es3_ray)
Пікірлер: 36