Today we are working on a wk2 Jeep Grand Cherokee Replacing a Radiator. More specifically on a 2011 Jeep Grand Cherokee 3.6L V6 model with out removing the ac condenser, lines or bumper.
Here's a DIY write up.
1.Disconnect the negative battery cable at battery.
2.Drain coolant from radiator.
3.Disconect from box and throttle body the air intake assembl.
4.Remove the upper radiator crossmember.
5.Disconnect the upper radiator hose.
6.Disconnect the overflow hose from radiator.
7.Remove the cooling fan assembly.
8.Remove the lower radiator hose from the water pump.
9.The lower part of the radiator is equipped with two alignment dowel pins and fit into rubber grommets. These rubber grommets are pressed onto the radiator.
10.Gently lift up and remove radiator from vehicle. Be careful not to scrape the radiator fins against any other component when installing a new one.
11.Completely remove the upper radiator hose if it does not allow you to pull the radiator out and pushes against the ac lines.
12.Swap everything over from the old radiator on to the new one. Rubber bushings, hoses, clips and etc. will vary from model to model.
13. Do everything in reverse to insall the radiator back in its place.
Parts links:
TYC Radiator - amzn.to/2VD09zZ
Radiator Cheaper - amzn.to/3AXtEMT
Mopar 5202 8974AA, Radiator Cap - amzn.to/3e7Wh0c
Zerex G05 Phosphate Free Antifreeze/Coolant concentrate - amzn.to/3eeQshs
Concentrate means, you will need to dillude it with disstilled water. Usualy 50/50 ratio.
Tools:
Clip remover set - amzn.to/3ySbwCw
Gearwrench set - amzn.to/3i0Gq4R this set makes my life easier on all of my jeep projects.
Music by: Epidemic Sounds
www.epidemicso...
#DIY #Jeep #Repair
Негізгі бет 2011 - 2014 Jeep Grand Cherokee WK2 radiator replacement
Пікірлер: 103