Note * make sure you rocker rail is in the correct up and down position. It has a notch one end and thats for both rails. They need to be up.
@VGHCX
Ай бұрын
Have the 2 plugs been proven to be better than 1 plug?
@briancastillo2911
Жыл бұрын
Thank you good sir you deserve more then blessings
@garrysrepairandcustomspeed7583
Жыл бұрын
No problem man
@gordonleakey6830
Жыл бұрын
I had a licensed mechanic working on my 5.7 Realizing after the fact the push rods were not. Installed properly and when the motor was put altogether it would have a terrible Rattle You couldn't understand it Took it for a test drive like this. I didn't agree with them found out later that we should be checking the push rods when he checked the push rods they were all bent what. Kind of damage could have done to this motor it wasn't run along under an hour but it was run on a highway
@gordonleakey6830
Жыл бұрын
I have 2012 dodge ram sport with the 5.7 did I hear this wright there is 2 size of rods ?
@garrysrepairandcustomspeed7583
Жыл бұрын
yes the long push rods go to the exhaust side the intake push rods are behind each intake port port and are shorter
@ricardocalderon8946
2 ай бұрын
When you put in the push rods is it supposed to snap into place?
@garrysrepairandcustomspeed7583
2 ай бұрын
no just slip into place
@AlottaSkillz252
8 ай бұрын
How much does this job cost?
@garrysrepairandcustomspeed7583
6 ай бұрын
its like almost 5 hours labor
@MontherAlcharbaji-mf2xr
Жыл бұрын
Did not mention the torque
@garrysrepairandcustomspeed7583
Жыл бұрын
im sorry im trying to explain alot in a short time
@mechwex
5 ай бұрын
@@garrysrepairandcustomspeed7583so what is the torque???
@SilentStorm21
5 ай бұрын
195 in lbs if i remember right (16 ft lbs)@@mechwex
@chickenchoker9000
Жыл бұрын
Pushrod will not fall through impossible
@garrysrepairandcustomspeed7583
Жыл бұрын
Well not exactly fall through but will seem shorter
@matthewsmart5796
5 ай бұрын
Sure won’t be able to grab it if you don’t have a magnet with a tiny head
@icepick859
4 күн бұрын
it won’t fall through but if you stick the intake push rod in the exhaust side, good luck getting that out
Пікірлер: 19