Great video, think I've the same problem, did you notice at 8:54 you'd bent the disc guard on refitting the ball joint ? you may want to check your rear axle bushes, at a guess these are also on their way out, if not knackered already.
@stevewalker9888
3 жыл бұрын
Great advice and great video. Thank you so much for sharing, my wife has one of those little cars. I need to go fix it 😃. Thanks again like and subbed. 🙏stay safe dude. From the uk 🇬🇧
@Mrocznyty
Жыл бұрын
6:13 the swingarm has one hole for the screw, which is not round but wide oval for this you need to do alignment
@philipmaguire9209
Жыл бұрын
Clunking on load only front suspension side might be mounting but I can't see rips in it ? Yet it's free rubber movement ?
@edyf3520
Ай бұрын
How to replace the inner arms of the stering rack....we appreciate it thanks pal
@aleddavies770
7 ай бұрын
Why does the front look wide and bulky? Does it have a kit or something?
@DEFENDINGELVISPRESLEY
Жыл бұрын
Thankyou
@leewalerzak
Жыл бұрын
Pretty sure your meant to raise the arm to to travel height and torque the bolts the bolts to a certain nm and an extra 180 degrees
@brianraymen3085
2 жыл бұрын
Hello mate im from the UK i need both mine doing on my fiesta 2013 could you tell me about how long it would take a mechanic to do both as iv been told the garage would need my car all day now i know its not too long a job would i be right in saying about 2 hours .
@FastEddieQ
2 жыл бұрын
Hello to Uk my friend…. Brian if you have the tools to do it, you can get it done in 2 hrs. Max….
@FastEddieQ
2 жыл бұрын
Unless shop has other things going on. But labor wise 2 hrs., For some one with out experience…. Good luck.
@FastEddieQ
2 жыл бұрын
Do it your self, you will save big money, and os simple to do
@brianraymen3085
2 жыл бұрын
@@FastEddieQ have been watching and does look easy enough but my biggest problem is my lower back i have very bad athritis and find it very difficult to bend down for any length of time if i had access to a car lift i would do my self.
@amandawillox2212
3 жыл бұрын
iPod video, however. Drive a large screwdriver into the gap on the ball joint ‘clamp’ and the ball joint drops out.
@PatrickMothata
2 ай бұрын
Can u show me how to replace ball joint
@jccastaneda1908
2 жыл бұрын
Thanks for the video
@brysonemmons687
3 жыл бұрын
Thanks Eddie!
@abdalqadr1
3 жыл бұрын
Greetings for you from Iraq
@FastEddieQ
3 жыл бұрын
Greetings my friend
@Mrocznyty
Жыл бұрын
My 2008 fiesta don’t have that much rust as your car, where you from bro
@FastEddieQ
Жыл бұрын
Wisconsin
@goldenratiogs4099
3 жыл бұрын
good one, I think you stay near the seashore lol!!
@PatrickMothata
2 ай бұрын
How to replace ball joint ford fiesta 2004
@alexdelarge5373
3 жыл бұрын
Any change to suspension components should be followed by an alignment check! Nice work though man. I like that you cleaned up surfaces and the ball joint bore in the hub, with a wire brush. Most people wouldn't do that.
@FastEddieQ
Жыл бұрын
Thanks 👍
@pablogarciavasquez6637
4 жыл бұрын
IT'S OK BUT IT WOULD BE BETTER IF YOU SPRAYED WITH WD40 OR BENCINA THE PARTS THAT YOU CLEAN WITH THE WIRE BRUSHES. BUT VERY GOOD WORK. GREETINGS FROM LIMA PERU.
@smokemirrors1531
3 жыл бұрын
HEY MAN - uk SAYs hello!
@FastEddieQ
Жыл бұрын
Thank you Pablo and Smokemirrors
@rapinncapin123
Жыл бұрын
Peru klk
@rapinncapin123
3 ай бұрын
That's a good bit of rust there buddy
@ivanstevenson_
3 жыл бұрын
Do the bolts just tighten right Into the frame of the car?
@FastEddieQ
3 жыл бұрын
Yes they do.
@MidwestNemo
3 жыл бұрын
This is a control arm replacement video.
@girinath1707
3 жыл бұрын
Sir, im from india Thank you for a great video i also have the same problem in my ford all new fiesta 2012 model while turning right side in steering i heard some hissing noise and in off road path more sound in right wheel. Can i get your whatsapp contact number ???
@FastEddieQ
3 жыл бұрын
Girinath, if you do some or a lot of off road driving, more than likely are going to be your Sway Bar Links front, check this out first, good lack.... don’t have whatsapp, but if question I’ll try to answer them here for you...
Пікірлер: 40