Why not cut the appearance panel in place. Really tough to get this back on.
@skorpio1905
2 жыл бұрын
я не знаю язык, но тут показано лучше и понятнее, чем на русских сайтах..спасибо
@alexroadro
4 жыл бұрын
Hello, what size are the screws that go to the chassis?
@josephineherra5659
5 жыл бұрын
Why cant you just cut the hole without removing the plastic piece???
@aaronlimon4803
5 жыл бұрын
Sometimes there are wires that run above the under body panels and the instructions will tell you to fully remove it so you don't accidentally cut any of the vehicle wires.
@josephineherra5659
4 жыл бұрын
Thanks Aaron
@naz220
4 жыл бұрын
@@taylorjbrost was there any wire(s) behind the plastic piece?
@naz220
4 жыл бұрын
At 6:47 you taped the washer on the wrong side. It should be taped on the other side/driver side instead.
@Fremen02
4 жыл бұрын
@@taylorjbrost you were installing it on a 2012 crv ? did you get the same hitch he mentioned, or some other one? I would really like to get a hitch for mine just want to make sure it will fit if I buy one online
Пікірлер: 9