hi did you do it? my g37x '09 is awd and looks pretty much rhe same, the only problem is i cant take the rack out, there is not enough room between the transmission and rack, any help would be appreciated i see your comment is recent.
@neverlyft9662
Ай бұрын
@@jonathanc8513did you figure this out
@REeLFUNNYsHortSs
10 ай бұрын
Great vid, I just don’t get the part where you hold steering
@blacksheepmediagroup4481
3 жыл бұрын
Great vid good job Congrats
@TheRealDanNguyen
3 жыл бұрын
Thanks
@ricky161981
3 жыл бұрын
Good job ..great video
@Willielee43
2 жыл бұрын
Good Job how many hours it took?
@bobaganoosh88
2 жыл бұрын
About 4 or 5
@Chris0
3 жыл бұрын
great video!!!
@lukeymontana27
2 жыл бұрын
Thanks for the video bro, question how did you block your steering when removing the steering shaft? Just by locking when u turn off the engine or u used the seatbelts to block? Sheers
@bobaganoosh88
2 жыл бұрын
I made the steering wheel lock or i made sure the steering wheel was straight when i took it off and never moved it when re installing. I did have to adjust a few times so making a mark on the shaft would help a lot.
@lukeymontana27
2 жыл бұрын
@@bobaganoosh88 thank you
@maclagat3865
2 жыл бұрын
You have a video of replacing seals?
@joshkullman505
3 жыл бұрын
How hard was it to remove that shaft by hitting it? I’ve been smacking mine forever and it won’t move!
@bobaganoosh88
3 жыл бұрын
Really really hard
@joshkullman505
3 жыл бұрын
@@bobaganoosh88 oh man I’ve been smacking this thing with no success. Does anything else have to be loosened off other than the 2 12mm bolts on the shaft? Thanks for your reply:)
@bobaganoosh88
3 жыл бұрын
@@joshkullman505 Ok you're talking about the two on the rack itself? That hold the lines onto it ?
@joshkullman505
3 жыл бұрын
@@bobaganoosh88 oh I’m talking about the lower/upper steering u joints. Seems it’s quite seized. Tried heating up,breaker bar, penetrant spray. At this point I think I might be doing something wrong lol
@bobaganoosh88
3 жыл бұрын
@@joshkullman505 like the ball joint similar to the tie rod ends? Need a good size hammer and really give it hell or one or more pickle forks in there. I've always had them come out with really hard hits from a hammer. Im in Michigan so usually I get some of the worst corrosion, when I do a little heat goes a long way.
@marksullymontelus3354
Жыл бұрын
hey i need your assistance abdly i have an infinty m37x steering rack issue please when you get this reach to mem please thank you
@MatthewSmith-to1hz
3 жыл бұрын
What about that electronic thing that screws into the rack? I cant get my off
@bobaganoosh88
3 жыл бұрын
Should be a pinch clip holding the connector onto the rack if I remember correctly.
@Engineerboy100
3 жыл бұрын
Good job, but next time, don't spend half the video on removing the cotter key lol :) jk
@bobaganoosh88
3 жыл бұрын
Any more rust and it would've taken 3/4 of the video! 😜
Пікірлер: 27