I guess turbo got no oil, clogged feed line ??? This Seems to be happening a lot. There is a feed line kit that solves that.
@psyhostrack2026
Жыл бұрын
Turbo separated from factory internal, lock nuts would of helped
@randomchill251
Ай бұрын
Help please: 14' Juke Turbo Failing? 138K miles. Up to date oil changes. Issue: When i start driving the car, if i floor it, it accelerates really fast. Recently I noticed that after 1.5-2 hours of driving, when I floor it, it takes a very ling time for the car to accelerate. It doesn't go over 2.5k rpm no matter what I do. It also makes a little whistling noise, like that of a turbo (i dont know much about cars) If i turn the car off and let it sit for 10 min, the issue disappears. No dash lights, no smoke or noises. What do you guys think? Thanks!
@erichavard3993
Жыл бұрын
I’m down to the last two bolts. I have the stubby 14mm wrench. I’m assuming you used the pry bar to get leverage and torque on the bolt head. I’m having trouble getting them to break lose. Any suggestions? Thanks in advance.
@erichavard3993
Жыл бұрын
How did you get the plastic connectors holding the wiring harness off the bottom of the metal plate below the top cowl panel? There a two stub outs through the upper heat shield that these connect to.
@psyhostrack2026
Жыл бұрын
I want to say they were the barbed clips and just a flat head screw driver or small pry bar worked great
@Adriankuku
Ай бұрын
I replaced turbo and now engine wants to start but hear a slight knocking sound. Any clue what can be?
@psyhostrack2026
Ай бұрын
Could be a lot of things easiest thing to check is oil, and drain oil cut open filter and see if there is any metal shaving in the filter median
@johnpacatang1308
Жыл бұрын
Hi sir. What code is the turbo fail? I have mine code po744 torque converter circuit problem. I losing power yesterday and i wont go up to 60mph. Pls help
@psyhostrack2026
Жыл бұрын
Thats in the Transmission always start by checking fuses and wiring then go to these, Checking and replacing transmission fluid; if the fluid is found to be very dirty, flushing the system and replacing the torque converter may be required. Checking and replacing any shorted or faulty wiring, connectors, and circuitry. Replacing the internal transmission harness.
@braggestkey1106
Жыл бұрын
How do you remove the wiper assembly I’ve been trying to figure it out that’s the only thing I can’t seem to do or find any removal videos
@psyhostrack2026
Жыл бұрын
Remove Wiper Arms to Start then there is clips in the Cowl. When you get to the Wiper motor there are 3 bolts and a plug. Then Final step is the tray/fire wall. i put a towel on the roof to put all parts on
@braggestkey1106
Жыл бұрын
@@psyhostrack2026 thank you for your help man this helped i successfully got it off and back on 🙏
@smittysmitty4681
Жыл бұрын
Don’t forget to replace the culprit to it failing in the first place (oil feed line)
Пікірлер: 15