Great video, the only thing id like to mention is you read your 6mm allen socket upside down as a 9 when taking off the crack pulley lol. Thanks for the video
@2EZEverything
Жыл бұрын
I’ll have to look at that! Thanks!
@mindfulmentally8437
Жыл бұрын
Mine had misfires on all cylinders w check engine light flashing & loss of power… replaced ignition coil (there is only one w the 4 cylinder thats why all 4 cylinders showed faults) … so far its working great! Also recently replaced the spark plugs.
@lukaszteplik1922
Жыл бұрын
There is misfire i would suggeste engine is not running properly scan it for the faults I think it broke and bend slightly valves Good luck Also Good job anyway
@VideoGameAtlas
Жыл бұрын
Good video. Something still seems wrong with the engine when you start it up.
@InboundG
2 ай бұрын
How’d you get the harmonic balancer off, it seems like the bolt in the middle is holding mine on or something
@2EZEverything
2 ай бұрын
The bolt in the center needs to come off it is a 13/16 socket
@InboundG
2 ай бұрын
@@2EZEverything I managed to get it off with a little leverage. The only thing that was a little tricky after that was the rad hose clip but once you get past that things move pretty quick
@logik8138
2 ай бұрын
Which engine is this?
@user-wj6gm1yg3o
10 ай бұрын
15:20 not sure if I missed it in the video but where did you get the parts from
@2EZEverything
10 ай бұрын
Autozone
@citizenjournalist429
Жыл бұрын
Good video, great commentary! Very useful!! 👍 For sure
@2EZEverything
11 ай бұрын
Thank you
@vip3r729
Жыл бұрын
How many miles did this engine have on it when you changed the belt?
@2EZEverything
Жыл бұрын
140,000
@BbyBackMosquitoRibs
Жыл бұрын
Lmao… I’m at 140,568. Going to do the replacement tomorrow. Thanks for the video, super hard to find repair videos on this car!
@2EZEverything
Жыл бұрын
@@BbyBackMosquitoRibs thanks for watching! Let us know how it goes for you.
@citizenjournalist429
Жыл бұрын
Mine has 92k and it's in the shop now for this 😭 I'm debating doing it myself and saving the 500$ in labor
@jaysrt21
3 ай бұрын
@@BbyBackMosquitoRibsglad you said that, I’m at 97k miles and was stressing out because VW recommended a timing belt replacement at 75k. Glad to know I got another 40k miles 😂
@jimx4052
Жыл бұрын
Does the crank have timing marks? I dont see any on mine
@2EZEverything
Жыл бұрын
Yes there is a small mark on the crank pulley that you can align it with
@Nathan-vl7xc
2 ай бұрын
Nope pull spark plug 1 stick something in when the piston is at the very top its the correct spot then just line the camshaft marks and all good
@lovepreetsinghhanjra1997
Жыл бұрын
Good job
@2EZEverything
Жыл бұрын
Thank you!
@gertis7420
10 ай бұрын
Is this an interference engine?
@2EZEverything
10 ай бұрын
Yes
@carlosc2114
10 ай бұрын
Sounds bad like valve interference or bend valve ..the belt snaps runing? You are in problems if not? Timming is wrong calibrated
@2EZEverything
10 ай бұрын
Yes it snapped running, it is my neighbors car, they haven’t had any issues with it other than the starter going out about a month ago but the engine smoothed out a bit after a while
@sherinton
3 ай бұрын
You definitely tap a couple valves that’s running really rough
@2EZEverything
3 ай бұрын
It ended up quitting down, my neighbor still drives it to this day.
@Abdul-nk4dy
8 ай бұрын
Bro please tell me how much does that cost
@2EZEverything
8 ай бұрын
Parts or labor?
@StarsAutoSport
7 ай бұрын
Good chance your valves impacted the pistons and aren’t fully closing. You may want to replace the valves in the future.
@2EZEverything
6 ай бұрын
The car’s idle smoothed out without doing anything, it’s my neighbor’s car and they drive it everyday with no complaints.
Пікірлер: 36