Bro my 78 c20 you just take off 2 bolts. These trucks a garbage now days
@user-km2ly2ld8v
2 ай бұрын
I took off the manifold shield and backed the motor mount bolt. I pulled out through wheel well
@Zyphen4866
9 ай бұрын
Saying this for ANYBODY that may find themselves here in the future... Go through the wheel well and remove the manifold heat shield it fucking comes right out with minimal shuffling around.
@ronaldst.mariejr3147
2 ай бұрын
Can you add the video of putting it in
@sgt.softbuck6236
Жыл бұрын
Just fought getting the starter out for an hr before finding this video. Thanks oscar!
@FloridaMan321
Жыл бұрын
I got it out, can’t get the new one back in. About to set the truck on fire
@AutoSteps
11 ай бұрын
even easier if you leave the bell housing bolt and the trans cooler lines in place and remove the exhaust manifold heat sheald and bring it up through the fender, way more room it basically jumps out
@lookingbehind6335
Ай бұрын
It’s more like putting a puzzle together while doing yoga. Better than trying to remove from the bottom.
@williamyeater7703
4 ай бұрын
I dig this type of video short sweet and to the point I doubt you're lying so I don't need to see the process. I have a 4 by 4 15 v6 and I'm headed out to do this right now hopefully it works
@christsogaugetrains
11 ай бұрын
would been nice to actually have a video showing the process. just saying
@marcywhitley6483
8 ай бұрын
Wish you were my neighbor I need help
@dylanprovencal5647
10 ай бұрын
This was exactly what I needed thanks. Still took my a good hour to get the new one in. Also used parachute cord to tie the tranny coolant lines down.
Пікірлер: 13