I replaced the 4 solenoid, bought original from Subaru on a 2016 Impreza and the code still showing as permanent, what do you suggest to do?
@NickBEADG
2 жыл бұрын
You have a ghost EVP at about 1:31. Can't tell what it says though. Ty for the video my sensors are all rusted.
@abdelcarfix2770
2 жыл бұрын
I checked and seem like everything is good lol.
@stevenbush4344
2 жыл бұрын
Replaced both intake silinoides. Hesitation problem GONE. Also took out that sufficating charcole filter cloging the air filter. Put in a K&N filter. Also running 93 gas. Whole different vehicle.
@abdelcarfix2770
2 жыл бұрын
Make sure you keep up with oil change. Use good oil
@stevenbush4344
2 жыл бұрын
@@abdelcarfix2770 I use the 0W-20 synthetik oil. Every 2,500 miles...
@abdelcarfix2770
2 жыл бұрын
yeah thats perfect
@911engineguy
Жыл бұрын
where to buy the sensors?
@abdelcarfix2770
Жыл бұрын
Any autoparts or online
@agentsjk9632
3 ай бұрын
I'm no engineer but I'm pretty sure that thinner than olive oil 0w20 has alot to do with oil consumption and various other oil related failures on most vehicles that use it. Switch to a quality 5w30, it'll barely lower fuel mileage and it actually sticks to stuff when hot.
@uberdang830
11 ай бұрын
Mine has oil leaking out of the connector.
@abdelcarfix2770
11 ай бұрын
Can't be from connector check valve cover
@uberdang830
11 ай бұрын
@abdelcarfix2770 It is from the connector. pins are covered in oil. I cleaned out the connector drove it a week and there was oil back in the connector. It can absolutely leek through the connector. There is only sealastic sealant that keep oil out of the connector. I'll make a video tomorrow when I replace the intake side. But both are leaking.
Пікірлер: 15