Good instructional video, just like everyone I was surprised about the loctite, but now i understand why you did it. Also marking the nut is a great idea to keep track of its movement.
@weron021
6 ай бұрын
Thank you. Hope this helps out.
@serhiymykhaylenko1549
Ай бұрын
Nice video, good explanation.
@weron021
Ай бұрын
@@serhiymykhaylenko1549 thank you
@nestormartinezmedina6573
5 ай бұрын
I tried this and mine makes the engine try to start. It doesn’t stay still, is there something I’m missing?
@weron021
5 ай бұрын
Yes, place the bike in gear and have some one hold the rear tire, also if you have a impact wrench this will help you out, was there a lock tite on it? if yes you may have to heat it up a bit.
@StrayAwayDave
Жыл бұрын
I enjoy the cherry loctite as well. Why did you take the pulley off? Did you have to replace it? Or just for instructional purposes?
@weron021
Жыл бұрын
My pulley bolt was loose and there was no loctite on it, so I know I have put too much but I rather have more than not enough.
@StrayAwayDave
Жыл бұрын
@@weron021 gotcha bud. Thanks for the video! If I ever need to do this, I know where to go ✌🏻
@rafak7078
9 ай бұрын
Hi! Is this front-rear play on the drive pulley when the gear is engaged normal?
@weron021
9 ай бұрын
Yes, there should be a bit of play.
@rafak7078
9 ай бұрын
@@weron021 Thanks for the answer. Recently I noticed that I also have such slackness, I thought something was wrong.
@weron021
9 ай бұрын
I had to adjust my belt once, and my nut was a bit loose that is why I have applied more than enough red locktite.@@rafak7078
@ericx7476
Жыл бұрын
That’s a Ton of loctite. A little bit is all you need
@weron021
Жыл бұрын
I know but I dont want that Nut to get loose, Thank you.
@dynaboi401
Жыл бұрын
Is there a clutch adjistment on the i side
@weron021
Жыл бұрын
You can adjust the cluch at the cluch leaver or on the right side of the bike.
@kieronoconnell2022
Жыл бұрын
You should be using a metric size socket. It's a nut, not a bolt.
Пікірлер: 20